User manual AEG-ELECTROLUX SANTO1410TK

[. . . ] as used in the outer wrapping and bags inside >PS< for polystyrene foam e. g. as used in the packing; this material is basically CFC-free The cardboard parts are made of waste paper and should be put back into the waste paper collection system. Commercial use Should you use your home refrigerator commercially or for purposes other than refrigeration of food and drinks, you must observe the legal requirements applicable to your area. Your freezer needs air Fig. 1 The refrigerating unit of your refrigerator is designed for maintenance-free operation. What it should never lack is good ventilation. [. . . ] For replacement, use a 13 amp BS 1362 fuse. Only ASTA approved or certified fuses should be used. The fuse cover/ carrier must be replaced in the event of changing the fuse. The plug must not be used if the fuse cover/ carrier is lost. A replacement cover/carrier must be obtained from an electrical goods retailer. If the socket outlets in your home are not suitable for the plug fitted to the appliance, then the plug must be cut off and an appropriate one fitted. When fitting the plug please note the following points: Important The wires in the mains lead are coloured in accordance with the following code: Green and Yellow Earth Blue Neutral Brown Live As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1. The wire which is coloured GREEN and YELLOW must be connected to the EARTH terminal in your plug, which is marked with the letter E or by the earth symbol or coloured GREEN, or GREEN and YELLOW. The wire which is coloured BROWN must be connected to the LIVE terminal which is marked with the letter L or coloured RED. The wire which is coloured BLUE must be connected to the neutral terminal which is marked with the letter N or coloured BLACK. Mounting under a continuous worktop Fig. 3 If installed under a continuous worktop, the appliance is fastened with a mounting screw (A) under the panel. Rehingeing the door Figs. 7 The plug socket necessary for connection of your appliance to the electricity supply should be positioned so that it is possible to pull out the appliance plug. If your appliance is installed under a continuous worktop, the plug socket should be provided as shown in Fig. A concealed protective contact plug socket requires 10 A/16 A fusing. Correct storage Fig. 9 1 = Butter and cheese 2 = Eggs, tubes, preserves 3 = Drinks 4= Cheese storage, fruit, and vegetables 5 = Meat, salami, cold cuts, dairy produce 6 = Ready meals, pastries, preserves Starting up and temperature regulation Fig. 8 Insert the plug of the connection lead into the plug socket with protective earth contact. When the refrigerator compartment door is opened, the internal lighting is switched on. The temperature selector knob is located on the RH side of the refrigerator compartment. Turning clockwise in direction "1": Refrigerating unit on, the latter then operating automatically. Setting "1" means: Highest temperature, warmest setting. Setting "6" (end-stop) means: Lowest temperature, coldest setting. The temperatures in the refrigerator compartment and freezer compartment cannot be independently regulated. [. . . ] Pull the plug out of the power socket or remove the fuse before changing the bulb. Unscrew the failed bulb and replace it with a new one of the same type. Bulb type: 240 V, 15 W (never, in any circumstances, fit a bulb larger than 15 W). Hints on proper use Store your food, depending on type and sensitivity, in the appropriate temperature zones. This will enable you to achieve an optimum storage duration (see illustration under "Correct storage"). [. . . ]