User manual AEG-ELECTROLUX SANTO1502-4TK

[. . . ] Ambient temperature has an effect on the power consumption of the unit. The appliance should therefore: ­ not stand in the direct sunshine, or close to a radiator or cooker ­ stand in a position where the ambient temperature corresponds with the climate category for which the appliance is designed. You will find data on this on the rating plate, which is in the interior of the appliance on the left hand side. It will consist of one of the following: Climate category Ambient temperature from . . . [. . . ] 621 814 002) B = Ventilation grille, white (E-No. 621 825 004) Detaching the worktop Fig. 2 After removal of the worktop of your refrigerator, the appliance can be installed under a continuous worktop. To do this, proceed as follows: Unscrew the Phillips screws (A). Slide the worktop around 20 mm backwards and lift upwards (B). Unscrew the clamping pins (C). Electrical connection WARNING - THIS APPLIANCE MUST BE EARTHED Please ensure that the voltage and current indicated on the rating plate agrees with the voltage of your electricity supply. If your appliance has been equipped with a mains 12 GB Mounting under a continuous worktop Fig. 3 If installed under a continuous worktop, the appliance is fastened with a mounting screw (A) under the panel. For this purpose, one of the rear mounting screws of the detached worktop can be used. If your appliance is installed under a continuous worktop, the plug socket should be provided as shown in Fig. A concealed protective contact plug socket requires 10 A/16 A fusing. Starting up and temperature regulation Fig. 8 Insert the plug of the connection lead into the plug socket with protective earth contact. When the refrigerator compartment door is opened, the internal lighting is switched on. The temperature selector knob is located on the RH side of the refrigerator compartment. Turning clockwise in direction "1": Refrigerating unit on, the latter then operating automatically. Setting "1" means: Highest temperature, warmest setting. Setting "6" (end-stop) means: Lowest temperature, coldest setting. a) For normal refrigeration, we recommend setting "3". If you require a lower temperature, select setting "4". b) For icemaking, rapid refrigeration, and shortterm storage of frozen food in the icemaking compartment, select setting "5" or "6". The internal temperature is strongly affected by the ambient temperature, loading, and frequent door opening. Rehingeing the door Figs. 4, 5, 6 Before connecting your appliance to the power supply, you should check whether the door hinge should be changed over from right (as delivered) to left if required by the installation site and operability. [. . . ] Do not open the door unnecessarily and close it again as quickly as possible. Set the most energy-saving frozen food storage temperature (see "Starting up and temperature regulation"). Keep the heat-emitting condenser (heat exchanger), the metal grille on the rear wall of your appliance, clean. Thoroughly clean it at least once per year. - - Hints on proper use Store your food, depending on type and sensitivity, in the appropriate temperature zones. [. . . ]