User manual AEG-ELECTROLUX SANTO2532IW5

[. . . ] Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/or the words (Warning!, Important!, Attention!). Please observe the following instructions carefully. Additional information regarding operation and practical applications of the appliance appear after this symbol. Tips and notes concerning economical and environmentally sound use of the appliance are marked with the cloverleaf. Printed on paper manufactured with environmentally sound processes. [. . . ] They can burst when the contents freeze, high carbonate content drinks can even explode!Never store lemonade, juices, beer, wine, sparkling wine etc. All foods must be packed air tight prior to freezing, so that they do not dry out or lose their flavour, and so that no flavour contamination of other frozen goods occurs. 9 Important!Do not touch frozen food with wet hands. To freeze fresh food rapidly, select thermostat setting 6, ensuring the temperature in the refrigerator compartment does not drop below 0C. You should promptly reset the temperature regulator to setting 3 or 4 if this occurs. Place the food to be frozen in the bottom drawer. Do not open the door frequently or leave it open longer than absolutely necessary. 2. Fill the ice cube tray 3/4 full with cold water, place it in the freezer compartment and leave to freeze. To loosen the frozen cubes, either bend the ice cube tray or hold it under running water for a few seconds. Never try to free an ice tray that is frozen to the freezer compartment using pointed or sharp edged objects. The appliance is near a heat Please see in the "Installasource. tion location" section. The food is too warm. Interior lighting does not work. Light bulb is defective. Please see in the "Changing the Light Bulb" section. 13 Heavy build up of frost, pos- Door seal is not air tight sibly also on the door seal. (possibly after changing over the hinges). Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx. At the same time shape the warmed door seal by hand such that it sits correctly. Unusual noises. Appliance is not level. The appliance is touching the wall or other objects. Readjust the feet. Move the appliance slightly. A component, e. g. a pipe, If necessary, carefully bend on the rear of the appliance the component out of the is touching another part of way. The compressor does not This is normal, no error has The compressor starts after start immediately after chan- occurred. Water on the floor or on sto- Water drain hole is blocked. See the "Cleaning and rage shelves. Care" section. If, after carrying out the necessary checks there is still a fault with your appliance please contact your local AEG Service Force Centre. [. . . ] For correct air circulation, it is important that the ventilation openings are not covered or obstructed. Important: If the appliance is positioned under a kitchen wall unit, a minimum clearance of 10 cm must be left between the top of the appliance and the overhanging wall unit. 18 Rear spacers Fit the rear spacers contained in the documentation bag to ensure even dissipation of heat genereted during operation. Proceed in the sequence illustrated by the numbers in figures. 1 2 AEG68 3 AEG69 Levelling the appliance Place the appliance on a flat hard floor. Two adjustable feet on the front of the appliance enable it to be accurately levelled by screwing them in or out as required. AEG70 Reversing the door The side at which the door opens can be changed from the right side (factory fitted) to the left side. [. . . ]