User manual AEG-ELECTROLUX SANTO3232-4KG

[. . . ] These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/ or with signal words (Warning!, Caution!, Important!). Please observe the following carefully. 1. [. . . ] The rear feet are adjusted by turning the screw in the front kick plate to the left or right. 7. If necessary, pads are supplied for the rear feet to make sliding the appliance in and out of the recess easier. To fit the pads, press them onto the rear feet. If required, the dimensions of these pads can be reduced by breaking them where marked. II52 2/a N. B. The joint cover (B) is to be assembled after having installed the appliance in the recess. 2 B 1 3 11 Installation 115° 4 8. Push the appliance into place and retain the cabinet with screws through the securing brackets into the worktop or adjacent woodwork as necessary. 5 9. To mount the furniture door proceed as shown in the figures: 10 1 2 a C 4 3 b 6 12 Installation 7 a C clic C b clic 8 c 13 Installation Upper part of kitchen furniture panel 1 = a Lower part of kitchen furniture panel = 2 275 275 ma x1 00 9 b 9/a 1 45 ° 2 3 10 = 10 = 11 14 Installation 12 10. Refit the covering strip. A 13 15 Installation Fitting the plinth Important!For the efficient operation of the appliance, it is important that the original ventilation grid is used. · For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=870 mm and a plinth height dimension b=150 mm. At this setting the compressor will be switched on and off as usual and automatic defrosting recommenced. 19 Switching off the appliance To switch off the appliance, turn the temperature regulator to position "0". If the appliance is not going to be used for an extended period: 1. Switch off the appliance by turning the thermostat knob to position "0". Remove the mains plug or switch off or disconnect from the electricity supply. Clean thoroughly (see section: "Cleaning and Care"). Leave the door open to avoid the build up of odours. Interior Accessories Storage shelves Various glass storage shelves are included with your appliance. The height of the storage shelves can be adjusted: 1. To do this pull the storage shelf forward until it can be swivelled upwards or downwards and removed. Please do the same in reverse to insert the shelf at a different height. Your appliance is equipped with two half size glass storage shelves. Storing tall items: Slide the front half of the Vario storage shelf in another level to the rear. By this means you will gain space to place tall items on the storage shelf below. 20 Variable Storage Box Some models are equipped with a variable storage box which is fitted under a door shelf compartment and can be slid sideways. The variable box can be hung from a storage shelf in the refrigerator compartment: 1. [. . . ] See the "Cleaning and Care" section. 24 Changing the light bulb Warning!Before changing the light bulb, switch off the appliance and unplug it, or disconnect from the power supply. To switch off the appliance, turn the thermostat knob to position "0". 2. To change the light bulb, undo the screw. [. . . ]