User manual AEG-ELECTROLUX SANTO4002

[. . . ] SN + 10 to + 32 °C N + 16 to + 32 °C ST + 18 to + 38 °C T + 18 to + 43 °C If installation beside a heat source is unavoidable, the following minimum distances at the sides are to be complied with: To electric cookers 3 cm, to oil or coal fired cookers 30 cm. Install a heat protection panel between the two appliances. The appliance should be installed on a firm, horizontal surface. Correct any floor irregularities by twisting the adjustable feet in or out. Appliance packaging information All materials used are environmentally compatible! [. . . ] A cut off plug inserted into a 13 amp socket is a serious shock hazard. Ensure that the cut off plug is disposed of safely. Voltage 220/240 V AC Fuse rating 13 amps See rating plate for further information. The rating plate is located inside the appliance. Your freezer needs air Fig. 1 The refrigerating unit of your refrigerator is designed for maintenance-free operation. What it should never lack is good ventilation. Air is supplied under the door through the ventilation slot between the refrigerator and storage surface. Air is extracted through the upper ventilation grille. Never obstruct these openings by plinth screens or crockery. If your refrigerator is installed under a continuous worktop, an air outlet opening of at least 200 cm2 and a ventilation grille (A/B) matching the worktop design should be provided at the rear of the worktop (Fig. The cut surfaces of the worktop (C) should be varnished to avoid swelling due to penetration of moisture. The appliance wall distance must be at least 30 mm and should be checked before the ventilation grille is inserted. 4, 5, 6 Before connecting your appliance to the power supply, you should check whether the door hinge should be changed over from right (as delivered) to left if required by the installation site and operability. Tilt the appliance slightly towards the rear and prop it securely. Unscrew the door hinge screws (K) and take the door bearing (1) downwards out of its cavity (Fig. Open the door a little way and take it out downwards. 5) and screw it into place on the opposite side. Fit the door into the upper pin (A) and close it. Insert the pin of the door bearing (1) into the left hand cavity and screw the bearing firmly into place with the screws (K). Unscrew the door handle and screw it in place on the left-hand side of the door. Use the plastic caps to cover the unused screw holes (Fig. 9 1= 2= 3= 4= 5= 6= 7= Butter and cheese Eggs, tubes, preserves Drinks Cheese storage, fruit, and vegetables Meat, salami, cold cuts, dairy produce Ready meals, pastries, preserves Icemaking compartment for rapid refrigeration, icemaking, and short-term storage of frozen food Cleaning before using for the first time Like all new appliances, your refrigerator will smell "new". For this reason, the interior of the refrigerator and all accessories should be cleaned before use (see also "Cleaning and care"). [. . . ] If the glass panel is defective, please approach your local glass retailer. The glass panel has the following dimensions: - width 427 mm - depth 245 mm - thickness 4 mm Have corners and edges ground. Hints on energy-saving One or two additional hints on energy-saving are given below: Do not install your refrigerator next to a radiator or oven. Through high ambient temperature, the temperature regulator switches on the refrigerating unit more frequently and for longer. Do not place any hot food in the refrigerator ­ first allow the food to cool to room temperature. [. . . ]