User manual AEG-ELECTROLUX SANTOU66000I

[. . . ] SANTO U 8 60 00 i Built-In Refrigerator Operating and Installation Instructions Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] 2. The wire coloured blue must be connected to the terminal marked "N" or coloured black. 3. The wire coloured brown must be connected to the terminal marked "L" or coloured red. 4. Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. A cut-off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut-off plug is disposed of safety. 207 13 AMP 17 Description of the appliance View of the appliance Butter/cheese compartment Sliding shelf Bottle shelf Vegetable drawers Storage shelves Thermostat Prior to Initial Start­Up 18 Please clean the appliance interior and all accessories prior to initial start-up (see section: "Cleaning and Care"). Starting up and temperature regulation Important!Only use the appliance when built­in!Connect the appliance to the mains electricity supply. When the refrigerator compartment door is opened, the internal lighting is switched on. The temperature selector knob is located on the right hand side of the refrigerator compartment. Turning clockwise in direction "1": Refrigerating unit on, the latter then operating automatically. Setting "1" means: Hightest temperature, warmest setting. Setting "6" (end-stop) means: Lowest temperature, coldest setting. Note: From a food safety point of view +5 °C should be considered sufficiently cold for storing food in the fridge. At a low ambient temperature of around 16°C, setting "1" should be selected. At ambient temperatures of around 25°C, select setting "2". If you require a lower temperature, select setting "3" or "4". AEG62 Important!on hot summer days) and a cold setting on the thermostat (position"5" to "6") can cause the compressor to run continuously. Reason: when the ambient temperature is high, the compressor must run continuously to maintain the low temperature in the appliance. The fridge will not be able to defrost since automatic defrosting of the fridge is only possible when the compressor is not running (see also "Defrosting" section). The result is the build up of a thick layer of frost on the fridge rear wall. If this happens, turn the thermostat knob back to a warmer setting (position "3" to "4"). At this setting the compressor will be switched on and off as usual and automatic defrosting recommenced. 19 Switching off the appliance To switch off the appliance, turn the temperature regulator to position "0". [. . . ] Press the light bulb cover as shown and slide it backwards. Refit the light bulb cover and the screw. Put the refrigerator back into operation. AEG65 Noises during Operation The following noises are characteristic of refrigeration appliances: · Clicks Whenever the compressor switches on or off, a click can be heard. · Humming As soon as the compressor is in operation, you can hear it humming. [. . . ]