User manual AEG-ELECTROLUX SB01ECEN

[. . . ] If you smell gas, make sure all gas connections are tight before operation. If you continue to smell gas call a qualified technician. - When lighting the burners, always pay close attention to what you are doing. Be certain you are pushing the igniter to light the burners you intend on using. WARNING If you smell gas: 1. [. . . ] Connect the other end of the flex line to the side burner valve. (See Fig 4) Note: This line can be extended using a 3/8" flared coupling and an additional flex line if necessary. Using pipe sealant, attach a 3/8" nipple to the bottom of the "T" fitting. Using pipe sealant, attach the NG gas regulator to the 3/8" nipple. Attach the NG gas line to the bottom flared fitting. (See Fig 7) Note: Make sure all fittings are tightened with a wrench. Fig. 6 Fig. Loosen the flex line attached to the side burner valve using an adjustable wrench. Remove the flex line completely from the side burner valve. Remove the control knob from the front of the side burner. Remove the screw holding the bezel in place on the side burner and remove bezel from front of side burner. Grasp and remove NG valve assembly from the side burner tube assembly and remove from the side burner. 5) Flex Line Underside of right side burner shelf Fig 1 Flex Line Valve Assembly Fig 2 6. Install LP valve assembly into the side burner. 6) Fig 3 Screw Bezel Fig 4 Fig 6 Fig 5 LP valve Assembly LP Side Burner Conversion 7. Reattach bezel and screw new LP valve onto front of side burner. Reattach the flex line to the LP valve assembly and tighten securely. Reattach the control knob onto the manifold stem. Looking down at top of side burner, use a 7mm nut driver to remove the NG. From the bottom of the side burner place the LP orifice into the main burner assembly, finger tighten. Using the 7mm nut driver tighten the LP orifice in the main burner assembly. This completes the side burner conversion. NG orifice Fig 7 Flex line attached Top of Side Burner Looking down Fig 8 LP orifice Fig 9 Bottom of side burner main assembly Fig 10 LP orifice Nut driver through top of side burner Fig 11 LP Grill Conversion IMPORTANT: Make sure you have converted the side burner to Liquid Propane prior to completing the following steps. Remove the LP gas hose assembly from the flare fitting. [. . . ] The date on the bill establishes the warranty period should service be required. If service is performed, it is in your best interest to obtain and keep all receipts. This written warranty gives you specific legal rights. You may also have other rights that vary from state to state. [. . . ]