User manual AEG-ELECTROLUX SC61841I

[. . . ] SANTO C 6 18 41 i Integrating Fridge Freezer Operating and Installation Instructions AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www. aeg. hausgeraete. de 2222 020-57 Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] When freezing fresh food, depress the ambient temperature switch (A) 12 hours before loading the food without modifying the thermostat setting. At the end of the freezing process, do not forget to depress again the ambient switch in order to avoid an increase of the power consumption. Place frozen foods in the drawers sorted by type, as far as possible. If large quantities of food are to be stored, remove all drawers and baskets from appliance and place food on cooling shelves. Pay careful attention not to exceed load limit stated on the side of the upper section Positioning This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located on the inside left of the appliance. The following table shows which ambient temperature is correct for each climate classification. Climate classification SN N for an ambient temperature of +10 to +32 °C +16 to +32 °C Ice pack There are two ice packs in one drawer of the freezer. In the event of a power failure or malfunction, the ice pack will lengthen the amount of time it takes for the frozen food to become too warm by several hours. The ice pack can only fulfil this task efficiently if it is placed in the uppermost drawer, at the front, above the frozen food. You can use the ice pack for cooling cold bags. The appliance should be located in a dry atmosphere, out of direct sunlight and away from continuous heat and extreme temperature, e. g. not next to a boiler or radiator, or in a very cold room e. g. warmer or colder, then the appliance may not operate correctly. For building-in and door reversal instructions please refer to the relevant instructions on the following pages. Your appliance needs air For safety reasons, minimum ventilation must be as shown Fig. Attention: keep ventilation openings clear of obstruction; 50 mm min. 200 cm 2 Preparation of Ice Cubes 1. Fill the ice cube tray 3/4 full with cold water, place it in the freezer compartment and leave to freeze. To loosen the frozen cubes, either twist the ice cube tray or hold it under running water for a few seconds. Never try to free an ice tray that is frozen to the freezer compartment using pointed or sharp edged objects. 200 cm 2 D567 Reversing the door The side the door opens can be changed from the right side (factory adjustment) to the left side, if the installation site requires. When changing the side the door opens, the appliance must not be connected to the mains. Remove plug from the mains beforehand. 10 19 Installation Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING ­ THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should these safety measures not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. [. . . ] · Put frozen food in the fridge to defrost. The cold in the frozen food will then be used to cool the fridge. Symptom Possible Cause The compressor does not start This is normal, no error has immediately after changing occurred. Water on the floor or on sto- Water drain hole is blocked. rage shelves. Remedy The compressor starts after a period of time. [. . . ]