User manual AEG-ELECTROLUX SC81840-6I

[. . . ] Mai 1999 2:04 14 g g Congratulations . . . . . . on the purchase of your new coffee machine. You have bought a modern and reliable appliance which you will certainly often enjoy using to make fresh and aromatic coffee. As with every technical appliance, there are some fundamental aspects of this coffee machine which must be noted and observed. [. . . ] Fill with water (Figure 4) Lift up the lid above the water tank. Remove the water tank and fill it with clear, cold tap water. 5. Switch on the appliance (Figure 8) Now switch on the appliance using the on/off switch (Figure 8/2). The operating lamp (Figure 8/1) lights up. 1 Never use hot water. Please never fill the water tank with milk, ready-made coffee, tea, etc. The cup markings are on the water tank (Figure 1/C). The markings refer to the quantity of fresh water. The resulting amount of coffee will be less, because the ground coffee soaks up water. Replace the water tank and close the lid. 3 To ensure that the coffee is uniformly strong, you should stir it in the jug after it has been made. 6. Remove the thermos jug When the thermos jug has been removed, the anti-drip valve (Figure 7) prevents surplus water from dripping onto the plate. Therefore make sure that the filter insert (Figure 9) is sitting properly. 5 SCOgb. book Seite 6 Freitag, 28. The required steam temperature is reached within a short time by turning the steam selector to the right. 0 Fill the receptacle (Figure 1/F), for instance with cold milk. 0 Connect the receptacle to the frothing nozzle (Figure 11). 3 Making cocoa You can make cocoa by adding cocoa powder to some milk in the receptacle and lightly stirring it. The cocoa is heated up by the hot steam in the frothing nozzle. The cocoa can also be frothed up if desired (see section "Froth or heat up milk"). SCOgb. book Seite 7 Freitag, 28. Mai 1999 2:04 14 g To heat water 0 Fill the receptacle with water. 0 Connect the receptacle to the frothing nozzle. 0 Switch off the appliance using the on/ off switch. Descaling the steam system Remove the steam nozzle by turning it an anti-clockwise direction. Screw on the descaling hose (Figure 2/F) and place a cup underneath. Switch on the steam selector several times for one minute. If necessary repeat the descaling procedure. [. . . ] The inner filter can then be removed (Figure 9). You should repeatedly press the anti-drip valve during cleaning, especially to remove all particles of coffee. Wipe the appliance with a damp cloth, but never immerse it under water !Wash out the thermos jug and lid with hot water, using a brush if necessary, and dry it with a cloth. [. . . ]