User manual AEG-ELECTROLUX SCA70

[. . . ] Februar 1999 10:12 10 g g Dear customer, Please read these operating instructions through carefully. Please make sure you read the safety instructions on the first pages of these operating instructions!Keep the operating instructions for future reference. Pass them on to any future owners. 1 Safety instructions The appliance may only be connected to the mains if the voltage, type of current, and frequency match the information on the rating plate (see underside of the appliance)! [. . . ] Coffee from already ground coffee (Figure 8) Fill with water (Point 1), insert filter paper (Point 2), add coffee powder, place coffee jug on the warming plate (Point 3), then press button 1 (Figure 1/ G). Coffee using the coffee grinder (Figure 9 and 10) Fill with water (Point 1), insert filter paper (Point 2), place coffee jug on the warming plate (Point 3). Put coffee beans in the bean container and adjust the grinding texture (Point 4). Then set the required number of cups on the rotary selector (Figure 1/F). Swivel the filter (Figure 9) to the left until it locks. When the grinding process is complete, the filter automatically swivels to the brewing position (Figure 10) and brewing commences. 5 SCA70gb_5. 5. book Seite 6 Montag, 1. Februar 1999 10:12 10 g Note: You can also vary the strength of the coffee with the rotary selector for the number of cups (Figure 1/F): e. g. 8 normal cups: rotary selector to 8 8 strong cups: rotary selector to 9 8 weak cups: rotary selector to 7, i. e. : you have the same quantity of water, but the grinder grinds more or less coffee for the swivel filter. setting you will get 10 cups of strong coffee. setting, vary the strength of the coffee, as in the past, via the amount of water. Switching off Switch the appliance off using button 1 (Figure 1/G). Warming plate (Figure 1/D) The warming plate keeps the coffee in the glass jug warm. The appliance automatically switches off 2 hours after brewing. Remove the jug (Figure 11) When the jug is removed, the anti-drip valve prevents dripping. Cleaning the Coffee Grinder (it is important that you observe these instructions) From time to time (at latest when a blockage occurs), it is necessary to clean the grinder channel to free it from oily coffee residues. To do this, proceed as follows: open the lid on the fresh water container and turn the screw (e. g. with a coin) on the grinder channel cover to open" (Figure 13). Take hold of the grinder channel cover at the front left and remove it slowly (Figure 14). Place a paper filter in the swivelling filter and rotate it to the grinding position until it clicks. brush), brush" the coffee residues into the paper filter (Figure 15). Another good way of removing coffee residues is to use a vacuum cleaner. In the case of a more serious blockage, in particular in the rear section of the grinder channel, run the grinder for 1 to 2 seconds to press out the blockage with freshly ground coffee. [. . . ] The foam polystyrene (PS) padding is free of CFCs. Please inquire with your local authority about your local recycling centre. Used coffee is ideally suited to composting. What to do, when . . . the pilot light (Figure 1/G) does not illuminate and grinding does not start after switching on? Move the rotary selector (Figure 1/F) to the perceptible notch for the required quantity of coffee and switch on the appliance again. [. . . ]