User manual AEG-ELECTROLUX SE 3.6 LI

[. . . ] It is also possible to connect to sockets without an earthing contact as the design conforms to safety class II. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents: EN 60745, EN 55014-1, EN 55014-2, EN 60335, EN 61000-3-2, EN 61000-3-3, EN 50366 in accordance with the regulations 98/37/EC, 2006/95/EC, 2004/108/EC CHARACTERISTICS After inserting the battery into the reception of the charger the battery will automatically be charged (yellow control lamp is illuminated continuously) When a hot or cold battery pack is inserted into the charger (flashing red lamp), charging will begin automatically once the battery reaches the correct charging temperature (NiCd/NiMh -5°C. Charging time varies depending on the battery temperature, charge needed and the type of battery pack being charged. [. . . ] This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. Read all safety warnings and all instructions, including those given in the accompanying brochure. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. SAFETY INSTRUCTIONS Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Contact with a , , live" wire will also make exposed metal parts of the power tool , , live" and shock the operator. Exposure to noise can cause hearing loss. Always wear goggles when using the machine. It is recommended to wear gloves, sturdy non slipping shoes and apron. Sawdust and splinters must not be removed while the machine is running. When working in walls ceiling, or floor, take care to avoid electric cables and gas or waterpipes. Remove the battery pack before starting any work on the machine. Do not dispose of used battery packs in the household refuse or by burning them. [. . . ] The contacts of chargers and battery packs must be kept clean. General note concerning NiMH batteries: The capacity of the battery is reduced when the temperature falls below -10°C. Long-term storage at temperatures higher than +40°C may have negative effects on the capacity of the battery. [. . . ]