User manual AEG-ELECTROLUX SEE621030108

[. . . ] These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/ or with signal words (Warning!, Caution!, Important!). This symbol guides you step by step in the operation of the appliance. [. . . ] Unscrew the holding bracket (H) and keep it in a safe place. F G H G 56/1 Mounting under a continuous worktop If installed under a continuous worktop, the appliance is fastened with a mounting screw (A) under the panel. A AEG96 54 Installation Reversing the door The side at which the door opens can be changed from the right side (as supplied) to the left side, if the installation site requires. When changing the side at which the door opens, the appliance must not be connected to the mains. Remove plug from the mains beforehand. 1. Tilt the appliance slightly towards the rear and prop it securely. 2. Unscrew the door hinge screws (K) and remove the hinge pin bracket (1). Position , , 0" = Refrigeration off Position , , 1" = Warmest interior temperature Position , , 6" = Coldest interior temperature 1. Plug the mains plug into the mains socket. Set the required temperature by turning the temperature regulator. The compressor starts and then runs automatically. Note: When the setting is changed, the compressor does not start immediately if automatic defrosting is currently taking place. Goods to be refrigerated can be loaded immediately after switching on, because the storage temperature in the refrigerator is quickly reached. Adjustment for tall goods (not for all models): Slide the front half of the Vario storage shelf in another level to the rear. By this means you will gain space to place tall items on the storage shelf below. Variable Inner Door The door compartments can be pulled up and removed, and inserted at other positions as needed. Bottle Holder (not for all models) Some models are equipped with a bottle holder in the bottle compartment. This is used to prevent individual bottles from falling over and can be slid sideways. 60 Variable Storage Box (not on all models, design differs depending on the model) Some models are equipped with a variable storage box which is fitted under a door shelf compartment and can be slid sideways. The box can be inserted under every door shelf compartment. To change, lift the shelf compartment with the box upwards and out of the holders in the door and remove the retaining bracket out of the guide under the shelf compartment. Please do the same in reverse to insert the shelf at a different height. The variable box can be hung from a storage shelf in the refrigerator compartment: 1. Pull the storage shelf forward until it can be tipped up or down and removed. Hang the retaining bracket on the taper on the storage shelf and slide the storage shelf back into the guides. Correct storage For physical reasons, there are different temperature regions in the fridge. The coldest region is on the lowest storage shelf. Warmer regions are the top storage shelf, the vegetable drawer and the storage compartments on the door. [. . . ] Refit the light bulb cover and the screw. Put the refrigerator back into operation. AEG65 65 Customer Service If you cannot find the remedy for a malfunction in these operating instructions, please contact your dealer or our customer service department. Addresses and telephone numbers are listed in the accompanying booklet "Guarantee Conditions/Customer Service Locations". Selective ordering of replacement parts can save unnecessary travel and costs. [. . . ]