User manual AEG-ELECTROLUX SEE625611104

[. . . ] The battery can be stored permanently in the charger without the danger of being overcharged. If both LEDs flash, either the battery has not been completely mounted or there is a fault in the battery or the charger. For safety reasons you must stop using the charger and battery immediately and have them inspected by an AEG Customer Service Centre. MAINTENANCE If the supply cord of this appliance is damaged, it must only be replaced by a repair shop appointed by the manufacturer, because special parts are required Use only AEG accessories and spare parts. [. . . ] Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/ service addresses). If needed, an exploded view of the tool can be ordered. As well as the machine type printed on the label and order the drawing at your local service agents or directly at: AEG Elektrowerkzeuge, Max-Eyth-Straße 10, D-71364 Winnenden, Germany. SYMBOLS Please read the instructions carefully before starting the machine. Typically, the A-weighted noise levels of the tool are: Sound pressure level (K = 3 dB(A)) . 56 dB (A) The noise level when working can exceed 85 dB (A). Total vibration values (vector sum in the three axes) determined according to EN 60745. *1 Measured according to AEG norm N 877318 *2 The values stated are reference values (2nd gear). actual values might differ , depending on the material and quality of the screws. WARNING The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure. use only System SE36 chargers for charging System SE36 battery packs. Do not use battery packs from other systems. Battery acid may leak from damaged batteries under extreme load or extreme temperatures. In case of contact with battery acid wash it off immediately with soap and water. In case of eye contact rinse thoroughly for at least 10 minutes and immediately seek medical attention. The following battery packs can be charged with this charger: voltage battery rating No. 5 Ah 1 Do not try to charge non-chargeable batteries with this charger. No metal parts must be allowed to enter the battery section of the charger (short circuit risk). Never break open battery packs and chargers and store only in dry rooms. Do not touch the tool with conducting objects. Before use check machine, cable, and plug for any damages or material fatigue. [. . . ] Before use check machine, cable, and plug for any damages or material fatigue. Repairs should only be carried out by authorised Service Agents. Only use the switch when the machine is at a standstill. BATTERIES New battery packs reach full loading capacity after 4 - 5 chargings and dischargings. [. . . ]