User manual AEG-ELECTROLUX SK61200I

[. . . ] These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/ or with signal words (Warning!, Caution!, Attention!). This symbol and numbered instructions guide you step by step in the operation of the appliance. [. . . ] In order not to impair the function of the appliance, never cover or obstruct the ventilation openings. Installation See installation instructions supplied. Please check whether, after installing your appliance and especially after rehingeing the door, the door seal seals right round. An untight door seal may lead to heavy frosting and thereby to a higher power consumption (see also , , What to do if. . . "). Electrical connection Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. 220 to 240 volts alternating current, 50 Hertz) The rating plate is inside the appliance on the left. A correctly installed, earthed socket is required for the electrical supply. The supply must have a fuse rating of at least 10 Amps. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. g. fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). The temperature regulator setting may therefore need to be adjusted to suit the specific conditions. 36 Recommended settings: Examples: Ambient temperature Approx. 38 °C Temperature controller position Range up to 1 Range about 2 Range about 2 2 to3 1 to2 Important!on hot summer days) and a cold setting on the temperature regulator (position"5" to "6") can cause the compressor to run continuously. Always lay bottles in the shelf with the top to the front. Small bottles and cans can be placed crossways in the holder. Place only unopened bottles or cans horizontally. 39 Interior Accessories Variable Storage Box (not on all models, design may differ depending on the model) Some models are equipped with a variable storage box which is fitted under a door shelf compartment and can be slid sideways. The box can be inserted under any door shelf compartment. To change the position of the storage box; lift the shelf compartment with the box upwards and out of the holders in the door and remove the retaining bracket out of the guide under the shelf compartment. Reverse the above operation to insert the shelf at a different height. The variable box can be hung from a storage shelf in the refrigerator compartment: 0 1. Pull the storage shelf forward until it can be tipped up or down and removed. Hang the retaining bracket on the taper of the shelf and slide the storage shelf back into the guides. Bottle Holder (not included with all models) Some models are supplied with a bottle holder in the bottle compartment. This is used to prevent individual bottles from falling over and can be slid sideways. 40 Correct Storage For physical reasons, there are different temperature regions in the fridge. The coldest region is on the lowest storage shelf. [. . . ] Refit the light bulb cover and the cross head screw. 1 3 Noises during Operation The following noises are characteristic of refrigeration appliances: · Clicks Whenever the compressor switches on or off, a click can be heard. · Humming As soon as the compressor is in operation, you can hear it humming. · Bubbling/Splashing When refrigerant flows into thin tubes, you can hear bubbling or splashing noises. Even after the compressor has been switched off, this noise can be heard for a short time. 45 Regulations, Standards, Guidelines This appliance was designed for household use and was manufactured in accordance with the appropriate standards. [. . . ]