User manual AEG-ELECTROLUX SK81203-5I

[. . . ] These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/ or with signal words (Warning!, Caution!, Important!). This symbol guides you step by step in the operation of the appliance. [. . . ] iappliances must therefore be provided with ventilation by having an opening in the furniture plinth. The warmed air must be able to be exhausted upwards through the air shaft on the furniture back. The ventilation cross-sections should be at least 200 cm2. Warning - To ensure the appliance functions correctly, never cover or obstruct the ventilation openings. min. 200 cm2 Installation Dimensioned drawings 28 Installation See installation instructions supplied. Please check whether, after installing your appliance and especially after reversing the door, the door seal seals right round. A badly fitting door seal may lead to heavy frosting and thereby to a higher power consumption (see also , , What to do if. . . "). Electrical connection A correctly installed, earthed socket is required for the electrical supply. The supply must have a fuse rating of at least 10 Amps. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. g. Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. 220 to 240 volts alternating current, 50 Hertz) The rating plate is inside the appliance on the left. 29 Description of the appliance View of the appliance (various models) 1 = Control panel 2 = Butter/cheese compartment with flap 3 = Variable storage box (not included with all models, design differs depending on the model) 4 = Door storage compartments 5 = Bottle compartment Bottle holder (not on all models) 6 = Fruit and vegetable drawers 7 = Storage shelves 8 = General purpose box (not included with all models) 9 = Moisture regulation (not on all models) 10 = Bottle / Can holder (not on all models) 11 = Rating plate 30 Prior to Initial Start­Up Please clean the appliance interior and all accessories prior to initial start-up (see section: "Cleaning and Care"). Starting up - Temperature regulation 1 Light switch 2 Temperature regulator and ON/OFF switch The temperature regulator is located at the top of the appliance on the control panel. The box can be inserted under every door shelf compartment. To change, lift the shelf compartment with the box upwards and out of the holders in the door and remove the retaining bracket out of the guide under the shelf compartment. Please do the same in reverse to insert the shelf at a different height. The variable box can be hung from a storage shelf in the refrigerator compartment: 1. Pull the storage shelf forward until it can be tipped up or down and removed. Hang the retaining bracket on the taper on the storage shelf and slide the storage shelf back into the guides. 35 Correct Storage For physical reasons, there are different temperature regions in the fridge. The coldest region is on the lowest storage shelf. Warmer regions are the top storage shelf, the vegetable drawer and the storage compartments on the door. The arrangement example shows at which places in the refrigerator suitable temperatures for various types of foods exist. Tip: Food in the fridge should always be covered or packaged, to prevent drying and tainting of other food. The following are suited for packaging: ­ Polyethylene airtight bags and wraps; ­ Plastic containers with lids; ­ Special plastic covers with elastic; ­ Aluminium foil. Defrosting The fridge defrosts automatically The rear wall of the fridge covers with frost when the compressor is running, and defrosts when the compressor is off. [. . . ] To change the light bulb, press on the rear hook and at the same time slide the light bulb cover in the direction indicated by the arrow. Put the refrigerator back into operation. Customer Service If you cannot find the remedy for a malfunction in these operating instructions, please contact your dealer or our customer service department. Addresses and telephone numbers are listed in the accompanying booklet "Guarantee Conditions/Customer Service Locations". Selective ordering of replacement parts can save unnecessary travel and costs. [. . . ]