User manual AEG-ELECTROLUX SKD71800S0

[. . . ] Technical data Installation Environmental concerns The following symbols are used in this user manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Subject to change without notice 4 Safety information SAFETY INFORMATION In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] · It is advisable to wait at least four hours before connecting the appliance to allow the oil to flow back in the compressor. 1) If the lamp cover is foreseen 2) If the lamp is foreseen 6 Operation · Adequate air circulation should be around the appliance, lacking this leads to overheating. To achieve sufficient ventilation follow the instructions relevant to installation. · Wherever possible the back of the product should be against a wall to avoid touching or catching warm parts (compressor, condenser) to prevent possible burn. · The appliance must not be located close to radiators or cookers. · Make sure that the mains plug is accessible after the installation of the appliance. · Connect to potable water supply only. 3) Service · Any electrical work required to do the servicing of the appliance should be carried out by a qualified electrician or competent person. · This product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable. OPERATION Switching on Insert the plug into the wall socket. Take care of not to damage the cooling system. 9 Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. After cleaning, reconnect the equipment to the mains supply. Defrosting of the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Use the special cleaner provided, which you will find already inserted into the drain hole. Periods of non-operation When the appliance is not in use for long periods, take the following precautions: · disconnect the appliance from electricity supply · remove all food · defrost 4)and clean the appliance and all accessories · leave the door/doors ajar to prevent unpleasant smells. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. WHAT TO DO IF. . . WARNING!Before troubleshooting, disconnect the mains plug from the mains socket. Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. 4) If foreseen. 10 What to do if. . . There are some sounds during normal use (compressor, refrigerant circulation). Problem Possible cause Solution Switch on the appliance. The appliance does not op- The appliance is switched off. The lamp does not operate. The mains plug is not connecConnect the mains plug to the ted to the mains socket correct- mains socket correctly. [. . . ] If you want to open the door to the left, follow these steps before you install the appliance: 1. Tighten the upper pin. 13 Ventilation requirements The airflow behind the appliance must be sufficient. 50 mm min. 200 cm2 Installing the appliance CAUTION!Make sure that the mains cable can move freely. [. . . ]