User manual AEG-ELECTROLUX SMART350

[. . . ] If damaged the cable should be replaced at an AEG Service Centre The Plug must be removed from the socket-outlet before cleaning or maintaining the appliance All service and repairs must be carried out by authorised AEG service staff Getting Started (see page 4) Check the dust bag is in place. Insert the hose until the catches click to engage. Attach tubes or telescopic tube to the hose handle and floor nozzle by pushing and twisting together. [. . . ] Dust bag safety device To avoid damaging the cleaner do not use it without a dust bag. A safety device is fitted which prevents the cover closing without a dust bag. Do not attempt to force cover shut. Dust bag indicator and changing the dust bag (see page 5) For peak performance the dust bag must be changed when full. If the dust bag should accidentally get broken in the cleaner, take cleaner to an AEG Service Centre for cleaning. Check the dust bag regularly and replace when necessary. The dust bag indicator window will gradually turn red when filling and completely red when full. To check the dust bag, the cleaner must be switched on, with all attachments connected and off the floor. The dust bag full indicator may signify that the bag is blocked (occasionally caused by very fine dust) which will cause loss of suction and may result in overheating. If this occurs change the dust bag even if it is not full. change the dust bag: Release catch and swing back lid before removing the dust bag. Insert new dust bag by fitting the bag slots over holders. Changing the filters (see page 5) There are two filters inside your cleaner. Never use the cleaner without the filters in place. To clean Motor Protection filter: The Motor Protection filter should be cleaned when dirty. Allow to dry and re-insert clean filter. [. . . ] In such cases, disconnect from mains and allow to cool for 2030 minutes. Clear blockage and/or replace filter(s) and restart. The clearing of blocked hoses is not covered by the guarantee. [. . . ]