User manual AEG-ELECTROLUX SMART487

[. . . ] To ensure total satisfaction, read this Instruction book carefully. Features (see page 3) Mains cable Cable rewind button On/off button Suction control Cover release catch for dustbag compartment F Dustbag indicator G Hose connection H Carrying Handle I Storage slot for floor nozzle and extention tubes when not in use J Storage slot for floor nozzle and extention tubes when in use K Accessory holder (integrated in the rear of the cleaner) A B C D E Always store in a dry place. Do not pick up hot cinder or lighted cigarette ends. Avoid tugging on the mains cable and check cable regularly for damage. [. . . ] Suction can also be regulated on the hose handle by opening/closing the aperture. Accessories (see page 4) Dust bags Telescopic tube Metal tubes (x2) (smart450) Swivel hose and handle with manual suction control Combination carpet/hard floor nozzle Narrow crevice nozzle Combination upholstery nozzle/brush Safety instructions The cleaner is for domestic use only and has been designed to ensure maximum safety and performance. Please follow these simple precautions: The cleaner is double-insulated so it must not be earthed. The cleaner is only to be used by adults. Young children or infirm persons should be supervised to ensure that they do not play with the appliance. 9 Getting the best results (see page 5) Carpets: Use the floor nozzle with the lever in horizontal position. Hard floors: Use the floor nozzle with the lever in vertical position. Loose rugs/curtains/lightweight fabrics: Reduce the suction power. Use the floor nozzle for loose rugs and the upholstery nozzle for curtains, cushions etc. Insert new dustbag by fitting the bag slots over holders. We recommend the dustbag is changed after using a carpet cleaning powder if there is a bad smell from the cleaner, then you should also change the filter Note: Use only AEG original dustbags and filters (ref GR51). Dustbag safety device: To avoid damaging the cleaner do not use it without a dustbag. A safety device is fitted which prevents the cover closing without a dustbag. Do not attempt to force cover shut. Confined areas: Use the crevice nozzle for crevices, corners and radiators. Dustbag indicator and changing the dustbag (see page 5) For peak performance the dustbag must be changed when full. If the dustbag should accidentally get broken in the cleaner, take cleaner to an AEG-Electrolux Service Centre for cleaning. Check the dustbag regularly and replace when necessary. The dustbag indicator window will gradually turn red when filling and completely red when full. To check the dustbag, the cleaner must be switched on, with all attachments connected and off the floor. The dustbag full indicator may signify that the bag is blocked (occasionally caused by very fine dust) which will cause loss of suction and may result in overheating. If this occurs change the dustbag even if it is not full. To change the dustbag Release catch and swing back lid before removing the dustbag. Remove the dustbag. Changing the filters (see page 5) There are two filters inside your cleaner. [. . . ] In such cases, disconnect from mains and allow to cool for 20-30 minutes. Clear blockage and/or replace filter(s) and restart. The clearning of blocked hoses is not covered by the guarantee. [. . . ]