User manual AEG-ELECTROLUX ST23001

[. . . ] We were thinking of you when we made this product Welcome to the world of Electrolux Thank you for choosing a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable. You find some examples on the cover in this manual. Please take a few minutes to study this manual so that you can take advantage of the benefits of your new machine. [. . . ] Ready ice cubes can be taken out of the tray under running water then twist or hit it. If the ice tray freezes to the compartment, avoid using metal tools or knife to take it out as the cooling system can be damaged. After finishing freezing it is practical to put the frozen food from the wire shelf in the frozen food compartment to the place under that making room for a next possible freezing. Adjustment of the wire shelf in the frozen food compartment (, , 2" positions) can be used only during storing, as freezing can be done only at the highest position of the wire shelf. Food already stored is not damaged by another freezing. (The goods when are put directly on the cooling plate freeze too fast!) Do not forget to keep to the storage time given on the packaging of frozen products if you buy them frozen. Some useful information and advice The variable shelves are worth paying attention to, which increases the usability of the fresh food compartment considerably. rearranging the shelves is also possible when the door is open at an angle of 90°. After opening and closing the door of freezer vacuum will rise inside the appliance because of the low temperature. So wait 2-3 minutes after Closing the door - if you want to open it again - while inner pressure equalises. Take care of operating the freezer at a position of thermostatic control so that the inside temperature can never go above -18 °C, since temperature higher than this can deteriorate frozen foods. It is practical to make sure of faultless operation of the appliance daily so as to notice possible failure in time and prevent deterioration of frozen foods. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from your municipal authorities. Clean the melting water outlet with the supplied pipe scraper that can be seen in the figure. the pipe scraper has to be stored in the outlet. The most typical case of clogging up in the melting water outlet when you put food wrapped in some paper into the appliance and this paper contacts back plate of the refrigerator and freezes to it. If you remove the food right at this moment the paper will tear and it can cause clogging up in the outlet by getting into it. So you are asked to be careful - because of the above - when placing foods wrapped in paper into the appliance. [. . . ] Following operations are to be done on the basis of figures and explanations: Disconnect the appliance from the electricity supply. It is recommended to ask another person for help, who can keep the appliance at this position safely. Unscrew on the both sides adjustable feet (2 pieces) and the fixing screws (2 pieces) of bottom door holder and the far side screws (2 pieces) too. Unscrew the top door holding pin of the freezer, then screw it back on the other side. [. . . ]