User manual AEG-ELECTROLUX STYLE 12

[. . . ] It is not close to a sink, bath or shower, or anywhere else where it might get wet. It is not close to other electrical equipment - fridges, washing machines, microwave ovens, TVs, fluorescent lights, etc. Installing (or replacing) the batteries (see P4) IMPORTANT: Before removing the battery compartment cover, always make sure the base unit is disconnected from the telephone line. Install 3 Alkaline AAA batteries into the battery compartment and place back the cover before use. [. . . ] 1 Making a call Lift the handset and listen for a dial tone. >The display shows the number as you dial (maximum of 14 digits will be shown) To end the call, return the handset to the base unit. 2 To answer a call When the phone rings: Lift the handset or press the speakerphone button on the base unit. >The call timer starts about 7 seconds after going on line. 3 To adjust the speakerphone volume During a call: Adjust the volume of the speakerphone to your comfortable volume level using the speakerphone volume. Replace the handset on the base unit cradle or press the speakerphone button >The speakerphone light indicator will turn off. 5 To switch between the handset and the speakerphone to speak During a phone conversation through the handset, press the speakerphone button hands-free. >Then the speakerphone light will turn on, but the conversation remains through the handset until the handset is replaced on the base unit cradle. >While in speakerphone mode, lift the handset to enable a private conversation. 7 Lift the handset or press the speakerphone button on the base unit. >The phone automatically dials the last number you called (maximum of 32 digits). 7 Mute function During a call press the mute button . >When the microphone is muted, the person at the other end of the call cannot hear you, but you can hear his side. To get back to the call, press the mute button again to release. 8 Use on PBX If you are using your phone on a PBX and the PBX user guide tells you to press Flashl Press the flash button on your phone. 9 Storing a number in (0-9) the indirect memories In standby mode, key in the telephone number you wish to store. Press the (0-9) button to store the number in the selected memory. 10 Dial out an (0-9) indirect memory number To dial a number stored in a two-touch indirect memory (0-9): Lift up the handset or press the speakerphone button . Key in the memory location number (0-9). 8 CALLER DISPLAY OPERATION VERY IMPORTANT: To use caller display you must first subscribe to your network provider’s caller display service. If you subscribe to a caller display service, you can see the phone number of the person calling you before you answer and in the calls list afterwards. The caller display information includes: The caller’s number The date and time of the call Condition of incoming caller information It is a repeated call It is a new call A call from someone whose number is with held (private call) REP NEW __P__ LCD screen will display UK 7. [. . . ] Dispose of the batteries in an environmental manner according to your country regulations. 13 CLEANING AND CARE Do not clean any part of your phone with benzene, thinners or other solvent chemicals as this may cause permanent damage which is not covered by the Guarantee. When necessary, clean it with a damp cloth. Keep your phone system away from hot, humid conditions or strong sunlight, and don‘t let it get wet. [. . . ]