User manual AEG-ELECTROLUX SU86000I

[. . . ] To reverse the opening direction of the door, proceed as shown in the figures: 1 4 5 2 3 1 29 Warning!After completion of the door reversing operation, check that the door gasket adheres to the cabinet. [. . . ] If the ambient temperature is cold (i. e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting. 2 6 7 8 10 13 9 12 11 3 Changing over the freezer compartment door (not on all models) Open the freezer compartment door a little way. Using a small screwdriver, press the spring in the opening of the lower door bearing slightly upwards and take the door bearing out complete with the door. 30 Position the covering cap (M) on the opposite side. Turn the freezer compartment door through 180° and fit the lower door bearing into the lower bearing cavity of the freezer compartment door. If required, the dimensions of these pads can be reduced by breaking them where marked. 2/a II52 32 The joint cover (B) is to be assembled after having installed the appliance in the recess. 2 B 1 3 115° 4 Screw appliance into place 5 33 Mounting furniture door 1 10 2 a C 4 3 b 6 7 a C clic C b clic 8 c 34 Upper part of kitchen furniture panel Lower part of kitchen furniture panel 1 a = 275 275 ma x1 00 = 9/a 2 9 b 1 45 ° 2 3 10 = 10 = 11 35 12 Refit the covering strip. A 13 36 Fitting the plinth Important!For the efficient operation of the appliance, it is important that the original ventilation grid is used. · For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=870 mm and a plinth height dimension b=150 mm. · For plinth heights greater than a=100 mm, b=150 mm, a cut should be made in the plinth, 580 mm wide, in the centre of the appliance position, leaving a remaining height of a=100 mm, b=150 mm. [. . . ] The same applies to an opening height dimension B=870 mm and a plinth height dimension b=150 mm. · For plinth heights greater than a=100 mm, b=150 mm, a cut should be made in the plinth, 580 mm wide, in the centre of the appliance position, leaving a remaining height of a=100 mm, b=150 mm. [. . . ]