User manual AEG-ELECTROLUX SV45-28

[. . . ] It will come in handy if you later sell the appliance or give it to somebody else. Prior to Installation · Check the appliance for transport damage. Under no circumstances should a damaged appliance be installed. In the event of damage please contact your retailer. Installation · · · This appliance is heavy. It is dangerous to alter the specifications or attempt to modify this product in any way. [. . . ] Do not place the thermometer hanging or lying directly on the shelf. · · · · Distribute foodstuffs to allow cold air to circulate freely between the products. Do not place food products directly against the cooling plate on the rear wall as they may freeze here. Also never put warm products into the appliance. Cover all foods properly to avoid odours and flavours from tainting other food. Switching off Turn the control anti-clockwise past the click position to "H". Remove the power supply plug from the wall socket. Electrolux 818 21 42-03/7 5 Cabinet interior The shelves and door compartments are removable and can easily be re-arranged. Certain shelves must be lifted up by the rear edge to enable them to be removed. The lower door compartment and the glass shelf above the salad drawer must not be moved. They are required for proper air circulation inside the cabinet. Shelves with a raised edge should be placed with the raised edge facing the rear wall of the cabinet, and thus prevent food products from touching the cooling plate. The vegetable box has two moveable partitions with five different choices in order to separate different vegetables. The vegetable box has a ventilation edging to increase the circulation of air and reduce the risk of condensation. Hanging half-shelf The half-shelf can be moved sideways. It can be hung under all door shelves, except the lowest one. Hints and Tips Energy Saving Advice · Do not install the cabinet close to sources of heat · · · such as a cooker, dishwasher or radiator. Locate the appliance in a cool well ventilated room and make sure that the air openings of the cabinet are not obstructed. · avoiding frequently opening the door or keeping it open too long. · not placing foodstuffs directly against the cold cooling plate. Electrolux 818 21 42-03/7 7 To change the light bulb The light is switched on automatically when the door is opened. Before replacing the light bulb, disconnect the power plug from the outlet. The power plug is not properly connected. Water comes out on the floor. The compressor operates continuously. The cabinet does not operate at all. Cooling or interior light does not operate. No indicator lamps light. Electrolux 818 21 42-03/7 8 Noise The refrigerating system will always produce some sounds. A pulsing sound is heard when coolant is pumped inside the cooling pipes. A ticking sound from the thermostat can be heard when the compressor switches on and off. The sound level varies depending on the operation of the cabinet. If you feel the sound level is incorrect: If the cushion spacers (between the cabinet wall and pipes) come loose, put them back in place again. [. . . ] In this case, the space behind the cupboard must be at least 50 mm deep. The appliance must be placed at a location whose ambient temperature corresponds to the climate classification*, for which the appliance is designed. * See on the rating plate on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classification. Climate classification SN N ST T for an ambient temperature of +10°C to +32°C +16°C to +32°C +18°C to +38°C +18°C to +43°C a) b) 50mm ·Check that the drain hose at the rear of the cabinet discharges into the drip tray. [. . . ]