User manual AEG-ELECTROLUX SW91822-4I

[. . . ] Never use the kettle if it has been dropped or if it shows any visible signs of damage. Contact one of the Electrolux Customer service centres or an authorised dealer for repair. Repairs to electrical appliances may only be carried out by a qualified electrician. Any improper repairs or tampering may seriously endanger the user. [. . . ] Make sure the lead does not dangle, especially while the kettle is in operation, as there is a danger of its beeing tipped over. Please always pull the plug out of the socket before cleaning it. Do not pull the plug out of the socket by tugging on the lead. Make sure the lead and plug are dry before the kettle is plugged in or switched on. Do not use the kettle when your hands are wet. Do not jerk the kettle around while it is in operation. Caution: Overfilling the kettle may lead to boiling water spraying out of it. For this reason, never fill it beyond the max. Protect the appliance and its cable from heat and wet. Only ever use the kettle for heating water!Never heat any foods, drinks, or food additives in it, and do not use it to boil milk or soup!Do not boil anything in the water in the kettle!1/A) to the I position. Operation Before using your new kettle for the first time, for hygienic reasons, you should clean it inside and out with a damp cloth. The minimum amount is 0. 25 litre (the min mark). Fill at least enough water to cover the heating coil. The water-level-markings on the inside will give you additional help. The maximum fill is 1. 0 (the max mark). SWK10. book Seite 3 Montag, 26. Juli 1999 12:00 12 your Electrolux kettle has the best possible protection against overheating. In this situation, the appliance should be send to an Electrolux service centre. For the sake of the environment Cleaning and care Disconnect the lead from the electricity supply every time before cleaning the kettle. This kettle is very easy to look after. The interior should be occasionally rinsed out with clear water and descaled at regular intervals as described below. The outside should simply be wiped with a damp cloth and dried thoroughly. Do not use any aggressive or abrasive cleaning products. [. . . ] Never use a damp cloth on the lead or plug. Make sure every time before using the kettle that the lead and plug are dry. Do not simply throw the packaging away, but follow these instructions: Cardboard packaging material can be handed in as salvage at your local wastepaper collection point. If the following packaging materials have been used: Plastic bags made of polyethylene (PE) can be handed in your local PE collection point. Padding made of expanded polystyrene (PS) is CFC-free and can be handed in to your local collection point (recycling depot). [. . . ]