User manual AEG-ELECTROLUX SZ91840-5I

[. . . ] These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/ or with signal words (Warning!, Caution!, Attention!). This symbol and numbered instructions guide you step by step in the operation of the appliance. [. . . ] Set the required temperature by pressing the , , +" and , , -" buttons (see section "Temperature setting buttons"). The temperature display will immediately show the changed setting. Each time the button is pressed the temperature is adjusted by 1 °C. 3 From a food safety point of view +5 °C should be considered sufficiently cold for storing food in the fridge. Once the required temperature has been set, after a short period (approx. 5 sec. ) the temperature display will change and again indicate the current ACTUAL temperature inside the fridge. The display will change from flashing to continuous illumination. The compressor will start and then run automatically. When the setting is changed, the compressor does not start immediately if automatic defrosting is currently taking place. 3 As the storage temperature within the fridge is reached quickly you can store food immediately after switching on. 39 COOLMATIC COOLMATIC Button The COOLMATIC function is suited for quick cooling of large quantities of goods in the refrigerator, e. g. The COOLMATIC function is switched on by pressing the COOLMATIC button. The COOLMATIC function now provides for intensive cooling. The temperature display will change and indicate in flashing numbers the DESIRED temperature that is currently set. Hold down the , , +" (WARMER) button until the temperature display indicates H (for holiday). The temperature shown in the temperature display will change in steps of 1 °C until it reaches +8 °C. After +8 °C the value +15 °C will appear in the display with the letter H. The fridge is now operating in energy-saving holiday mode. After a few seconds the temperature display will again change to the ACTUAL temperature. The display will change from flashing to continuous illumination. Do not store any goods in the refrigerator when the standby mode is operational. The temperature is regulated at about +15°C when the stand-by mode is operational. This is too warm for food products. 41 Interior Accessories Storage Shelves Your appliance is equipped with glass storage shelves. The glass shelf above the fruit and vegetable compartment must always remain in this position so that fruit and vegetables stay fresh longer. [. . . ] Refit the light bulb cover and the cross head screw. Noises during Operation The following noises are characteristic of refrigeration appliances: · Clicks Whenever the compressor switches on or off, a click can be heard. · Humming As soon as the compressor is in operation, you can hear it humming. · Bubbling/Splashing When refrigerant flows into thin tubes, you can hear bubbling or splashing noises. Even after the compressor has been switched off, this noise can be heard for a short time. 49 Regulations, Standards, Guidelines This appliance was designed for household use and was manufactured in accordance with the appropriate standards. [. . . ]