User manual AEG-ELECTROLUX T56837

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance. [. . . ] (The laundry should be taken out towards the end of the anti-crease phase at the latest to prevent creases from forming. ) If LONG ANTICREASE ANTIKREUK LANG function has been selected, the anti-crease phase is lengthened by 60 minutes. Before removing the laundry, remove fluff from the micro-fine filter. It is best to use a damp hand for this purpose. (See "Care and cleaning" chapter. ) 3. After each drying cycle: - Clean the micro-fine filter and fine filter - Drain the condensed water container (See chapter "Care and cleaning". ) 5. Close the door. Care and cleaning 19 Care and cleaning Cleaning fluff filter The filters collect all the fluff which accumulates during drying. To ensure that the dryer works perfectly, the fluff filters (micro-fine filter and fine strainer) must be cleaned after every drying cycle. The warning led is on to remind you this operation. Never operate the dryer without fluff filters or with damaged or blocked fluff filters. Open loading door Use a damp hand to clean the micro- fine filter, which is built into the lower part of the loading aperture. 3. After a period of time, a patina due to detergent residue on laundry forms on the filters. When this occurs, clean the filters with warm water using a brush. Operating when the heat exchanger is blocked with fluff can damage the dryer. To do this, press the release button on the bottom of the door aperture and open the door in the plinth to the left. Clean fluff from the inside of the door and the heat exchanger front chamber. Wipe the door seal with a damp cloth. Care and cleaning 4. Turn both lock washers inwards. 23 5. Use the handle to pull the heat exchanger out of the base and carry it horizontally to prevent any remaining water from spilling. To empty the heat exchanger, hold vertically over a washing-up bowl. It is best to use a brush or to rinse thoroughly with a hand-held shower. Replace heat exchanger and lock into place (turn both lock washers outwards until they snap into place). Never operate the dryer without the heat exchanger. Cleaning the drum CAUTION!Do not use abrasives or steel wool to clean the drum. [. . . ] Press snap-in button G in and G down, press cover down slightly and remove from front of the machine. Disconnect cable connector from cover G. Change door lock F over to the opposite side, insert the cable connector and screw down the door interlock. On the other side, insert the cable connector in cover G, insert cover and allow snap-in button to lock into place. [. . . ]