User manual AEG-ELECTROLUX T56845L

[. . . ] The information marked with this symbol provides additional instructions and practical tips on the use of the appliance. Tips and information about economical and ecological use of the machine are marked with the clover symbol. Should any problems arise, this booklet provides instructions on how to solve them by yourself; see section "Something not working?". If this information is not sufficient, please contact our nearest Service centre (address and telephone numbers are indicated on the enclosed leaflet). Printed on recycled paper. [. . . ] Before removing the laundry, remove lint from the micro-fine filer. It is best to use a damp hand for this purpose (refer to "Cleaning and maintenance" section). After each drying cycle ­ clean the micro-fine filter and fine strainer, ­ drain the condensate tank (refer to the "Cleaning and maintenance" section). 16 125983990. qxp 2006-04-21 07:12 Page 17 Cleaning and maintenance Cleaning fluff filter To ensure that the dryer works perfectly, the fluff filters (micro-fine filter and fine strainer) must be cleaned after every drying cycle. Never operate the dryer without fluff filters or with damaged or blocked fluff filters. Use a damp hand to clean the microfine filter, which is built into the lower part of the loading aperture. 3. Push down unlock button on large mesh filter. It is best to use a damp hand for this purpose. 17 125983990. qxp 2006-04-21 07:12 Page 18 Clean the entire filter area The strainer area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. Remove fluff from the entire filter area. It is best to use a vacuum cleaner for this purpose. Lime in the water or cleaning agents may form a barely visible lining on the inside of the drum. The degree to which the laundry has been dried is then no longer detected reliably. The laundry is damper than expected when removed from the dryer. vinegar-based cleaner) to wipe down the inside of the drum and drum ribs. Clean operating screen and housing Caution!Do not use furniture cleaners or aggressive cleaning agents to clean the machine. Use a damp cloth to wipe down the operating screen and housing. What to do if . . . Troubleshooting by yourself If, during operation, the error code (E plus number or letter) appears on the multi-display: Switch the machine off and on again. Press the START/PAUSE button If the error is still displayed, please inform your local Service Force Centre and quote the error code. Problem Possible cause Mains plug is not plugged in or fuse is not working correctly. Remedy Plug in at mains socket. Check fuse in fuse box (domestic installation). Press the START/PAUSE button again. Dryer does not work. Loading door is open. Have you pressed the START/ PAUSE button? 21 125983990. qxp 2006-04-21 07:12 Page 22 Problem Possible cause Remedy Select a different programme the next time you dry Wrong programme selected. (see "Overview of programmes" section). [. . . ] displacement length: 3m 30 125983990. qxp 2006-04-21 07:12 Page 31 Warranty conditions Great Britain We, AEG, undertake that if within 12 months of the date of the purchase this AEG appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our discretion repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: · The appliance has been correctly installed and used only on the electricity or gas supply stated on the rating plate. · The appliance has been used for normal domestic purposes only, and in accordance with the manufacturer's operating and maintenance instructions. · The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. · All service work under this guarantee must be undertaken by a Service Force Centre. [. . . ]