User manual AEG-ELECTROLUX T57800

[. . . ] 125987210. qxp 2006-12-04 10:12 Page 1 LAVATHERM T57800 Condensation dryer User Information PERFEKT IN FORM UND FUNKTION 125987210. qxp 2006-12-04 10:12 Page 2 Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. The warning triangle and/or the key words (Warning!, Caution!) emphasize information that is particularly important for your safety or correct functioning of the appliance. This symbol guides you, step by step, in the operation of the appliance. [. . . ] If the condensate tank is full, an active programme will break off automatically and the EMPTY WATER display will light up. In order to continue the programme, the condensate tank must first be emptied. The condensate is not suitable for drinking or for preparing foodstuffs. 1. Take out drawer containing condensed water container completely (1) and pull up the condensed water container's drainage pipe as far as it will go (2). 2. Pour condensed water out into a basin or similar receptacle. 3. Slide outlet connections in and refit condensate tank. If the programme has been interrupted as a result of the condensate tank being full: Press the START/PAUSE button to continue the drying cycle. The water reservoir has a volume of approx. This is sufficient for around 6 kg of laundry which has previously been spun at 800 revolutions/ minute. The condensate can be used as distilled water, e. g. However first filter the condensate (e. g. with a coffee filter) to remove any residue and small pieces of fluff. 17 125987210. qxp 2006-12-04 10:13 Page 18 Cleaning heat exchanger If the HEAT EXCHANGER display is illuminated, the heat exchanger needs to be cleaned. Operating when the heat exchanger is clogged with lint can damage the dryer. This also increases energy consumption. 1. To do this, press the release button on the bottom of the loading opening and open the door to the left. Remove lint from the inside of the door and the heat exchange chamber. Use the handle to pull the heat exchanger out of the base and carry it horizontally to prevent any remaining water from spilling. To empty the heat exchanger, hold vertically over a washing-up bowl. It is best to use a brush or to rinse thoroughly with a shower head. Replace heat exchanger and lock into place (turn both lock washers outwards until they snap into place). The dryer will not operate if the HEAT EXCHANGER indicator is still lit. Caution!Never operate the dryer without the heat exchanger. 18 125987210. qxp 2006-12-04 10:13 Page 19 Cleaning the drum Caution!Do not use abrasives or steel wool to clean the drum. Lime in the water or cleaning agents may form a barely visible lining on the inside of the drum. [. . . ] Any appliance or defective part replaced shall become the Company's property. · This guarantee is in addition to your statutory and other legal rights. · Home visits are made between 8. 30am and 5. 30pm Monday to Friday. Visits may be available outside these hours in which case a premium will be charged. [. . . ]