User manual AEG-ELECTROLUX T57860

[. . . ] Tips and information about economical and ecological use of the machine are marked with the clover symbol. Should any problems arise, this booklet provides instructions on how to solve them by yourself; see section "Something not working?". If this information is not sufficient, please contact our nearest Service centre (address and telephone numbers are indicated on the enclosed leaflet). Printed on recycled paper. People who think ecologically, act accordingly. . . 2 125985010 gb. qxp 2006-06-12 13:15 Page 3 Contents Operating Instructions. [. . . ] The laundry can be removed at any time during the crease guard phase. (The laundry should be taken out towards the end of the crease guard phase at the latest to prevent creases from forming. ) 1. Before removing the laundry, remove lint from the micro-fine filer. It is best to use a damp hand for this purpose (refer to "Cleaning and maintenance" section). After each drying cycle ­ clean the micro-fine filter and fine strainer, ­ drain the condensate tank (refer to the "Cleaning and maintenance" section). Close loading door. 14 125985010 gb. qxp 2006-06-12 13:16 Page 15 Cleaning and maintenance Cleaning fluff filter To ensure that the dryer works perfectly, the fluff filters (micro-fine filter and fine strainer) must be cleaned after every drying cycle. Never operate the dryer without fluff filters or with damaged or blocked fluff filters. Use a damp hand to clean the microfine filter, which is built into the lower part of the loading aperture. 3. Push down unlock button on large mesh filter. It is best to use a damp hand for this purpose. 15 125985010 gb. qxp 2006-06-12 13:16 Page 16 Clean the entire filter area The strainer area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. The dryer will not operate if the HEAT EXCHANGER indicator is still lit. Never operate the dryer without the heat exchanger. Cleaning the drum Caution!Do not use abrasives or steel wool to clean the drum. Lime in the water or cleaning agents may form a barely visible lining on the inside of the drum. The degree to which the laundry has been dried is then no longer detected reliably. The laundry is damper than expected when removed from the dryer. vinegar-based cleaner) to wipe down the inside of the drum and drum ribs. Clean operating screen and housing Caution!Do not use furniture cleaners or aggressive cleaning agents to clean the machine. Use a damp cloth to wipe down the operating screen and housing. 18 125985010 gb. qxp 2006-06-12 13:16 Page 19 What to do if . . . Troubleshooting by yourself If, during operation, the error code (E plus number or letter) appears on the multi-display: Switch the machine off and on again. Press the START/PAUSE button. If the error is still displayed, please inform your local Service Force Centre and quote the error code. Problem Possible cause Lint filter clogged. SPECIAL CARE button pressed and load volume too big. [. . . ] Parts replaced free of charge become our property. So as to avoid more severe damage, the defect must be brought to our attention immediately. Applying the guarantee is subject to the consumer providing proof of purchase showing the purchase and/or delivery date. The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. [. . . ]