User manual AEG-ELECTROLUX T7022TK

[. . . ] 7022 TK Electronic User manual Condenser Dryer 2 Dear Customer Thank you for choosing one of our high-quality products. With this appliance you will experience the perfect combination of functional design and cutting edge technology. Convince yourself that our appliances are engineered to deliver the best performance and control - indeed we are setting the highest standards of excellence. In addition to this you find environmental and energy saving aspects as an integral part of our products. [. . . ] It is best to use a vacuum cleaner for this purpose. Press both journals of the large mesh filter into the brackets on the loading door until they snap into place. Press against the large mesh filter until it locks into the interlock. Care and cleaning 19 If the fine strainer is not fitted, the large mesh filter will not snap into place and the loading door cannot be closed. Cleaning the door seal Wipe the door seal with a damp cloth immediately after the drying cycle has finished. Emptying the condensate tank Empty condensate tank after every drying cycle. If the condensate tank is full, an active programme will break off automatically and the warning led TANK (BEHÄLTER) light up. In order to continue the programme, the condensate tank must first be emptied. The condensate is not suitable for drinking or for preparing foodstuffs. Take out drawer containing condensed water container completely 1 and pull up the condensed water container's drainage pipe as far as it will go 2. 2 1 20 Care and cleaning 2. Pour condensed water out into a basin or similar receptacle. Slide outlet connections in and refit condensate tank. If the programme has been interrupted as a result of the condensate tank being full: Press the START PAUSE button to continue the drying cycle. The condensate tank has a volume of approx. This is sufficient for around 6 kg of laundry which has previously been spun at 1000 revolutions/ minute. The condensate can be used as distilled water, e. g. However first filter the condensate (e. g. with a coffee filter) to remove any residue and small pieces of fluff. Cleaning heat exchanger If the warning led CONDENSER (WÄRMETAUSCHER) is lighting, the heat exchanger needs to be cleaned. Operating when the heat exchanger is blocked with fluff can damage the dryer. To do this, press the release button on the bottom of the door aperture and open the door in the plinth to the left. Clean fluff from the inside of the door and the heat exchanger front chamber. Wipe the door seal with a damp cloth. Care and cleaning 4. Turn both lock washers inwards. 21 5. Use the handle to pull the heat exchanger out of the base and carry it horizontally to prevent any remaining water from spilling. To empty the heat exchanger, hold vertically over a washing-up bowl. [. . . ] On the other side, insert the cable connector in cover G, insert cover and allow snap-in button to lock into place. Insert loading door and hinges into recesses on the front of the machine and screw down. Note regarding contact protection:The machine is only secure for operations again once all plastic parts have been inserted. 7. Special accessories Intermediate installation kit for stacked washer and dryer: Available from your Service Force Centre or your specialist dealer These intermediate installation kits can be used to arrange the dryer and an automatic AEG-Electrolux washing machine (60cm wide, front loading) as a spacesaving washer/dryer stack. The automatic washing machine is at the bottom and the dryer is at the top. [. . . ]