User manual AEG-ELECTROLUX T7023TK

[. . . ] Pour des raisons de sécurité et dans le but de garantir un usage correct de l'appareil, nous vous invitons à lire attentivement cette notice d'utilisation, ainsi que les recommandations et les avertissements qu'elle contient avant de procéder à l'installation et à la première utilisation de l'appareil. Contents Thank you for choosing one of our high-quality products. To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. [. . . ] The appliance must not be installed behind a lockable door, a sliding door a door with a hinge on the opposite side to that of the appliance in such a way that a full opening of the dryer is restricted. Before use all parts of the transport packaging must be removed. Pull off adhesive strips from inside machine on top of drum. Details on mains voltage, type of current and the fuses required should be taken from the type plate. The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precautions. Should the appliance power supply cable need to be replaced, this must be carried out by our Service Center. The plug must be accessible after installing the machine. A B Unscrew hinge A from the front of the machine and take off the loading door. To do this, insert B A a thin screwdriver into the slots as shown in the illustration, press downwards slightly and pry out the cover plates. Use an appropriate tool and exert pressure to unfasten locking block C from the snapon fixture, take out and re-insert on the other side having rotated the block through 180°. Unscrew hinge A from the loading door, rotate through 180°, re-insert on the opposite side and screw down. Re-insert cover plates B on the opposite site having first rotated them through 180°. Unscrew cover plates D from the front D E of the machine, rotate through 180°, F F screw on the opposite side. Unscrew door lock E , push down slightly D and remove from the front of the machine. Press snap-in button F in and down, press cover down slightly and remove from front of the machine. Change door lock E over to the opposite side, screw down the door interlock. On the other side, insert cover F and allow snap-in button to lock into place. Insert loading door and hinges into recesses on the front of the machine and screw down. Note regarding contact protection: The machine is only secure for operations again once all plastic parts have been inserted. Stacking kit These intermediate installation kits can be used to arrange the dryer and a washing machine (60 cm wide, front loaded) as a space-saving washer/dryer stack. the washing machine is at the bottom and the dryer is at the top. Read carefully the instructions supplied with the kit. [. . . ] No drum light Abnormally elapsing time on the LCD5) Programme inactive Drying cycle to short Programme selector in OFF position. Time to end is calculated on the basis Automatic process; this is not a maof: type, volume and dampness of launchine fault. Select time programme or higher drying level (e. E51 - only dryers with the LCD): Switch the dryer off and on. [. . . ]