User manual AEG-ELECTROLUX T71273AC

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance. [. . . ] If nevertheless there is an attempt to change the programme on the programme knob, the programme progress display and the maintenance indicators flash. If an option button (excluding the BUZZER option) is pressed, Err appears in the multidisplay. The drying programme is not however affected by this (laundry protection). 22 Daily use Putting in extra items or taking items out before end of programme 1. Press the START PAUSE button to continue the drying cycle. Drying cycle complete / removing laundry Once the drying cycle is complete, display shows a blinking "0", under anticrease icon appear dash. If the BUZZER option has been chosen, an acoustic signal sounds intermittently for about one minute. The drying cycles (except for the SHOES RACK (SPORTSCHUHE) and WOOL RACK (TROCKNUNGSKORB) programmes) are automatically followed by an anti-crease phase which lasts around 30 minutes. The drum rotates at intervals during this phase. This keeps the laundry loose and free of creases. The laundry can be removed at any time during the anti-crease phase. (The laundry should be taken out towards the end of the anti-crease phase at the latest to prevent creases from forming. ) If function has been selected, the anti-crease phase is LONG ANTI-CREASE lengthened by 60 minutes. Before removing the laundry, remove fluff from the micro-fine filter. It can be positioned with the tooth facing to the left or to the right). After cleaning do not forget to put it back. 26 Care and cleaning 4. Push down unlock button on large mesh filter. It is best to use a damp hand for this purpose. Clean the entire filter area The strainer area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. Remove fluff from the entire filter area. It is best to use a vacuum cleaner for this purpose. Press both journals of the large mesh filter into the brackets on the loading door until they snap into place. Press against the large mesh filter until it locks into the interlock. Care and cleaning 27 If the fine strainer is not fitted, the large mesh filter will not snap into place and the loading door cannot be closed. Cleaning the door seal Wipe the door seal with a damp cloth immediately after the drying cycle has finished. Emptying the condensate tank Empty condensate tank after every drying cycle. If the condensate tank is full, an active programme will break off automatically icon on the display will light up. In order to continue and the EMPTY CONTAINER the programme, the condensate tank must first be emptied. [. . . ] Disconnect cable connector from cover G. Change door lock F over to the opposite side, insert the cable connector and screw down the door interlock. Installation 41 13. On the other side, insert the cable connector in cover G, insert cover and allow snap-in button to lock into place. Insert loading door and hinges into recesses on the front of the machine and screw down. [. . . ]