User manual AEG-ELECTROLUX T76488IH1

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance. [. . . ] The drum rotates at intervals during this phase. This keeps the laundry loose and free of creases. The laundry can be removed at any time during the anti-crease phase. (The laundry should be taken out towards the end of the anti-crease phase at the latest to prevent creases from forming. ) If LONG ANTICREASE KNITTERSCHUTZ PLUS function has been selected, the anti-crease phase is lengthened by 60 minutes. Before removing the laundry, remove fluff from the micro-fine filter. It is best to use a damp hand for this purpose. (See "Care and cleaning" chapter. ) 3. After each drying cycle: - Clean the micro-fine filter and fine filter - Drain the condensed water container (See chapter "Care and cleaning". ) 5. Close the door. 17 18 Care and cleaning Care and cleaning Cleaning fluff filter The filters collect all the fluff which accumulates during drying. To ensure that the dryer works perfectly, the fluff filters (micro-fine filter and fine strainer) must be cleaned after every drying cycle. The warning led is on to remind you this operation. However first filter the condensate (e. g. with a coffee filter) to remove any residue and small pieces of fluff. Cleaning heat exchanger If the warning led is lighting, the heat exchanger needs to be cleaned. Operating when the heat exchanger is blocked with fluff can damage the dryer. To do this, press the release button on the bottom of the door aperture and open the door in the plinth to the left. Clean fluff from the inside of the door and the heat exchanger front chamber. Wipe the door seal with a damp cloth. 22 Care and cleaning 4. Use the handle to pull the heat exchanger out of the base and carry it horizontally to prevent any remaining water from spilling. To empty the heat exchanger, hold vertically over a washing-up bowl. It is best to use a brush or to rinse thoroughly with a hand-held shower. Replace heat exchanger and lock into place (turn both lock washers outwards until they snap into place). Never operate the dryer without the heat exchanger. Cleaning the drum CAUTION! [. . . ] Disconnect cable connector from door lock F. Press snap-in button G in and G down, press cover down slightly and remove from front of the machine. Disconnect cable connector from cover G. Change door lock F over to the opposite side, insert the cable connector and screw down the door interlock. [. . . ]