User manual AEG-ELECTROLUX T8030TW

[. . . ] and please pass it to any future owner of the appliance. We wish you much joy with your new appliance. OPERATING INSTRUCTIONS IMPORTANT SAFETY INFORMATION ENVIRONMENT INSTALLATION Transporting the appliance Appliance positioning Removing transport safety packaging Electrical connection Changing door stop Special accessories PRODUCT DESCRIPTION CONTROL PANEL Control panel Display BEFORE FIRST USE PROGRAMME CHART DAILY USE Sorting laundry Average laundry weights Switching appliance/drum light on Laundry loading Selecting the programme 81 81 83 84 84 84 84 85 85 86 87 88 88 88 89 89 91 91 92 92 92 93 93 INTENSIVE (TROCKNEN PLUS) function 93 LONG ANTI-CREASE (KNITTERSCHUTZ PLUS) function 93 BUZZER (SIGNAL) function 94 TIME (ZEITWAHL) function 94 DELAY START (ZEITVORWAHL) 94 CHILD LOCK function 94 Starting the programme 95 Changing programme 95 Laundry unloading 95 CARE AND CLEANING 96 Cleaning fluff filter 96 Cleaning the door seal 97 Emptying the water reservoir 97 Cleaning heat exchanger filters 98 To clean the drum 100 Clean operating screen and housing 100 WHAT TO DO IF . 101 MACHINE SETTINGS 102 TECHNICAL SPECIFICATIONS 103 SERVICE 104 Subject to change without notice In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. [. . . ] Unscrew hinge A from the loading door, rotate through 180°, re-insert on the opposite side and screw down. Re-insert cover plates B on the opposite site having first rotated them through 180°. Installation Unscrew cover plates D from the front D of the appliance, rotate through 180°, E F F screw on the opposite side. Unscrew door lock E , push down D slightly and remove from the front of the appliance. Push snap-in button F in and down, push cover down slightly and remove from front of the appliance. Change door lock E over to the opposite side, screw down the door interlock. On the other side, insert cover F and allow snap-in button to lock into place. Insert loading door and hinges into recesses on the front of the appliance and screw down. Note regarding contact protection: The appliance is only secure for operations again once all plastic parts have been inserted. Stacking kit These intermediate installation kits can be used to arrange the dryer and a washing machine (60 cm wide, front loaded) as a space-saving washer/dryer stack. the washing machine is at the bottom and the dryer is at the top. The child lock can be set to prevent a programme being accidentally started or a programme in operation being accidentally changed. the child lock function locks all buttons and the programme knob. The child lock can be activated or deactivated by holding down the LONG ANTI-CREASE (KNITTERSCHUTZ PLUS) (3) and BUZZER (SIGNAL) (4) buttons simultaneously for 5 seconds. ­ Before programme is started: Appliance cannot be used ­ After programme is started: Programme in operation cannot be changed The icon appears in the display to indicate that the child safety device is activated. The child safety device is not deactivated once the programme comes to an end. If you want to set a new programme, you must first deactivate the child safety device. When program is started only current cycle phase is indicated by single icon. To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to OFF (AUS) and then reset the programme. The programme cannot longer be changed directly once the programme has started. The drying programme is not however affected by this (laundry protection). Once the drying cycle is complete, display shows a blinking , anti-crease icon appears on LCD. [. . . ] Select time programme or higher drying level (e. No drum light Abnormally elapsing time on the LCD5) Programme inactive Drying cycle to short E51 - only dryers with the LCD): Switch the dryer off and on. 5) only dryers with the LCD 6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section). Only use a special bulb which is designed specially for dryers. [. . . ]