User manual AEG-ELECTROLUX T86585IH

[. . . ] We promise that it'll make your life a little easier. Good luck! 136901261-00-17102007 4 electrolux Contents Operating Instructions Important safety information Product description Control panel Before first use Sorting and preparing laundry Programme overview Daily use Drying rack Care and cleaning What to do if . . . Machine settings Technical data Consumption values Hints for test institutes Installation Environment 5 5 8 9 10 10 12 17 26 29 36 40 42 43 43 44 50 Service 52 important safety information electrolux 5 Operating Instructions Important safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. [. . . ] The child lock can be activated or deactivated by holding down the Option and OK buttons simultaneously for 5 seconds. ­ Before programme is started: Appliance cannot be used ­ After programme is started: Programme in operation cannot be changed icon appears in the display to indicate that the child safety device is actiThe vated. The child safety device is not deactivated once the programme comes to an end. If you want to set a new programme, you must first deactivate the child safety device. Starting the programme Press the Start/Pause button. The programme is started. 24 electrolux daily use The programme progress is shown in LCD by appropriate set of icons. From left to the right, from IRON DRY to ANTI-CREASE icon depends on the drying cycle chosen. in case of CUPBOARD programme the following status icons are visible: . Current cycle progress is marked by flashing dash under status icon. When appropriate part of drying cycle is accomplished dash becomes steady and appears flashing under next status icon. Changing programme To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to OFF Aus and then reset the programme. The programme can no longer be changed directly once the programme has started. If nevertheless there is an attempt to change the programme on the programme knob, the programme progress display and the maintenance indicators flash. If an option button is pressed, Err appears in the multidisplay. The drying programme is not however affected by this (laundry protection). Putting in extra items or taking items out before end of programme 1. 8. care and cleaning electrolux 29 Care and cleaning Cleaning fluff filter The filters collect all the fluff which accumulates during drying. To ensure that the dryer works perfectly, the fluff filters (micro-fine filter and fine strainer) must be cleaned after every drying cycle. The warning icon is on to remind you this operation. Never operate the dryer without fluff filters or with damaged or blocked fluff filters. Use a damp hand to clean the micro- fine filter, which is built into the lower part of the loading aperture. 3. After a period of time, a patina due to detergent residue on laundry forms on the filters. When this occurs, clean the filters with warm water using a brush. 30 electrolux care and cleaning Remove the filter from the door pulling it out. It can be positioned with the tooth facing to the left or to the right). After cleaning do not forget to put it back. 4. Push down unlock button on large mesh filter. It is best to use a damp hand for this purpose. Clean the entire filter area The strainer area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. care and cleaning electrolux 31 8. Remove fluff from the entire filter area. [. . . ] Disconnect cable connector from door lock F. Press snap-in button G in and down, press cover down slightly and remove from front of the machine. Disconnect cable connector from cover G. installation electrolux 49 12. Change door lock F over to the opposite side, insert the cable connector and screw down the door interlock. [. . . ]