User manual AEG-ELECTROLUX TAGL2E100

[. . . ] Important safety information Product description Control Panel Before first use Sorting and preparing laundry Programme chart Daily use 19 21 21 22 22 23 25 Cleaning and maintenance What to do if . Subject to change without notice In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] Press the (DELAY) DEPART DIFFERE button as many times as necessary until the required time of the delay appears on the display, e. If the display is showing H and you press the button again, the time delay will be cancelled. Setting child lock The child lock can be set to prevent a programme being accidentally started or a programme in operation being accidentally changed. the child lock function locks all buttons and the programme knob. The child lock can be activated or deactivated by holding down the (LONG ANTICREASE) ANTIFROISSAGE and (BUZZER) ALARME buttons simultaneously for 5 seconds. ­ Before programme is started: Appliance cannot be used ­ After programme is started: Programme in operation cannot be changed The icon appears in the display to indicate that the child safety device is activated. The child safety device is not deactivated once the programme comes to an end. If you want to set a new programme, you must first deactivate the child safety device. From left to the right, from drying , anticrease , to cooling . Changing programme To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to (OFF) ARRET position. The programme can no longer be changed directly once the programme has started. If nevertheless there is an attempt to change the programme on the programme knob or if an function button (excluding the(BUZZER) ALARME button) is pressed, led above (START PAUSE) DEPART PAUSE button starts flashing temporarily in yellow. The drying programme is not however affected by this (laundry protection). Drying cycle complete / removing laundry Once the drying cycle is complete, display shows a blinking " 0 ", under anti-crease and filter icon appear dash. ZER) ALARME button has been pressed, an acoustic signal sounds intermittently for about one minute. The drying cycles are automatically followed by an anti-crease phase which lasts around 30 minutes. the drum rotates at intervals during this phase. This keeps the laundry loose and free of creases. The laundry can be removed at any time during the anti-crease phase. (The laundry should be taken out towards the end of the anti-crease phase at the latest to prevent creases from forming. Before You place the filter, please check it there is nothing inside the filter seat. Clean the filter after each drying cycle. [. . . ] If the hose is partially squashed, drying efficiency will be reduced, resulting in longer drying times and higher energy consumption. If the hose is completely squashed, the safety cut-outs with which the machine is fitted may operate. When operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance. Door reversal To make it easier to load or unload the laundry, the door can be reversed. [. . . ]