User manual AEG-ELECTROLUX TASL3M

[. . . ] INSTALLATION AND MAINTENANCE OF WA SL3 M TK SL3 M TA SL3 M WASHING MACHINE TUMBLE DRYER INDEX 2-15 16-34 36 CONTENTS ­ WASHING MACHINE SAFETY 3 CHANGING SETTINGS 10­11 Transit screws General Child lock on Start/Stop button Door Overfill cut-out Packaging Transport/Winter storage Scrapping PARTS OF THE WASHING MACHINE TECHNICAL INFORMATION 4 4­5 Language Locking the programme Wash temperature, C or F Changing preset wash temperature Child lock MAINTENANCE 12­13 Emptying/cleaning trap and drain pump Inspection holes under drum paddles Cleaning the detergent drawer Cleaning the outside of the machine In areas with hard water TROUBLESHOOTING 14­15 Technical data Programme cycles MECHANICAL INSTALLATION 6­8 Transit screws Positioning the washing machine Adjusting the feet Connecting to water supply Water intake ­ mixed or cold water Connecting to drain ELECTRICAL INSTALLATION 9 Door will not open Machine will not start Error messages The display is lighting when a program me is selected, but no characters or digits are shown Wrong language displayed Electrical installation Connecting to coin mechanism WASHING MACHINE CONTENTS 2 SAFETY GENERAL TRANSPORT/WINTER STORAGE · Read and keep this manual!· Any electrical work or plumbing must be carried out by qualified tradesmen. · Remove the transit screws before you use the machine, see Mechanical installation. CHILD LOCK ON BUTTON If you intend to transport the machine or store it over winter in unheated premises, empty the trap and the drain pump, see the chapter on Maintenance. Call service. SCRAPPING To prevent accidental button pushes on the button you can activate the child lock function. [. . . ] Built-in The tumble dryer can be installed free-standing, built-in or stacked on top of a washing machine. Remember that the dryer generates heat and should not therefore be placed in a room that is too small. If the room is very small, drying will take longer due to the limited volume of air. TIP! The tumble dryer can be built in under a worktop with a minimum height of 850 mm. The gap must be at least 600 mm wide. To improve the air supply, leave open the door of the room in which the dryer is placed. WARNING! min 850 min 600 Electrical installation must be carried out by a qualified electrician. A. Free-standing 120 140 103 0 12 135 140 The tumble dryer can be placed next to the washing machine. The dimensions of the tumble dryer are: 585 mm C. Stacked 1 2 3 4 5 6 7 8 The tumble dryer can be stacked on top of an Electrolux Wascator WE 50 washing machine. Use the stacking kit that is supplied with the machine: 2 plastic holders. Attached to the lower back of the machine. 595 mm 850 mm An optional pull-out top can be purchased from your dealer: Art no. 80 619 07-0 (white) and 80 619 07-33 (black). TUMBLE DRYER MECHANICAL INSTALLATION 20 Fit the stacking kit as follows: 1. Unscrew the two arrowed screws at the rear of the washing machine. 4. Position the plastic cups so that the arrowed lugs are flush with the front and side of the top, then press down onto the top. Fit the metal brackets as shown, using the screws. Open the knock-out holes on the back of the tumble dryer (where present) with the aid of a hammer and screwdriver. They must not be fully removed, just opened! 6 Slide the tumble dryer under the metal brackets, keeping the front edge raised 1­2 cm. tic cups that will hold the front feet of the tumble dryer must be attached to the top of the washing machine. This is important since the feet of the tumble dryer must be located in the plastic cups to ensure that the dryer is correctly positioned. Break tab A off the cup that goes on the right side and break tab B off the cup that goes on the left side. Then peel the backing paper off the self-adhesive base of the cups. B A ADJUSTING THE FEET Screw the feet in or out until the dryer is steady and level on the floor or washing machine. Lower the front feet of the dryer into the plastic cups and adjust the feet so that the dryer is level. MECHANICAL INSTALLATION TUMBLE DRYER 21 CONDENSED WATER (only applies to condenser tumble dryer) Connect the vent hose as follows: The machine is supplied with a 2. 0 metre-long drain hose. Use this to remove the condensed water. 1. Slide the vent hose over the end of the adapter and secure with the plastic strap. [. . . ] If this does not help, call service. TUMBLE DRYER 33 Maximum programme duration. After the machine has run for the maximum time (3 hours) it automatically stops. Check and replace any blown fuses in the fuse box. To cancel the error message, switch off the machine or open the door. [. . . ]