User manual AEG-ELECTROLUX TD 425 U W

[. . . ] We promise that it'll make your life a little easier. Good luck! 136901700-00-02102007 4 electrolux Contents Operating Instructions Important safety information Product description Control panel Before first use Sorting and preparing laundry Programme overview Daily use Care and cleaning What to do if . . . Machine settings Technical data Consumption values Hints for test institutes Installation Environment 5 5 8 9 9 9 11 14 21 28 31 33 34 34 35 39 Service 42 important safety information electrolux 5 Operating Instructions Important safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. [. . . ] Turn the programme knob to the TIME programme Zeitprogramm. If nevertheless there is an attempt to change the programme on the programme knob, the programme progress display and the maintenance indicators flash. If an option button (excluding the BUZZER Signal button) is pressed, Err appears in the multidisplay. The drying programme is not however affected by this (laundry protection). Putting in extra items or taking items out before end of programme 1. Open loading door. Laundry and drum can become hot. Press the Start/Pause button to continue the drying cycle. Drying cycle complete / removing laundry Once the drying cycle is complete, display shows a blinking "0". If the BUZZER Signal button has been pressed, an acoustic signal sounds intermittently for about one minute. The drying cycles are automatically followed by an anti-crease phase which lasts around 30 minutes. The drum rotates at intervals during this phase. This keeps the laundry loose and free of creases. The laundry can be removed at any time during the anti-crease phase. (The laundry should be taken out towards the end of the anti-crease phase at the latest to prevent creases from forming. ) If LONG ANTI-CREASE Knitterschutz Plus function has been selected, the anti-crease phase is lengthened by 60 minutes. 20 electrolux daily use 1. If the programme has been interrupted as a result of the condensate tank being full: Press the Start/Pause button to continue the drying cycle. The condensate tank has a volume of approx. This is sufficient for around 7kg of laundry which has previously been spun at 1000 revolutions/ minute. care and cleaning electrolux 25 The condensate can be used as distilled water, e. g. However first filter the condensate (e. g. with a coffee filter) to remove any residue and small pieces of fluff. Cleaning heat exchanger If the warning led CONDENSER Wärmetauscher is lighting, the heat exchanger needs to be cleaned. Operating when the heat exchanger is blocked with fluff can damage the dryer. To do this, press the release button on the bottom of the door aperture and open the door in the plinth to the left. Clean fluff from the inside of the door and the heat exchanger front chamber. 4. Turn both lock washers inwards. 26 electrolux care and cleaning 5. Use the handle to pull the heat exchanger out of the base and carry it horizontally to prevent any remaining water from spilling. To empty the heat exchanger, hold vertically over a washing-up bowl. Do not use sharp objects to clean. It is best to use a brush or to rinse thoroughly with a hand-held shower. Replace heat exchanger and lock into place (turn both lock washers outwards until they snap into place). Close door in plinth. Never operate the dryer without the heat exchanger. Cleaning the drum Do not use abrasives or steel wool to clean the drum. care and cleaning electrolux 27 Lime in the water or cleaning agents may form a barely visible lining on the inside of the drum. [. . . ] Unscrew door lock F, push down slightly and remove from the front of the machine. Disconnect cable connector from door lock F. Press snap-in button G in and down, press cover down slightly and remove from front of the machine. Disconnect cable connector from cover G. [. . . ]