User manual AEG-ELECTROLUX TD425 U SB

[. . . ] Never stop a tumble dry before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. Contents Thank you for choosing one of our high-quality products. To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. [. . . ] To do this, inB A sert a thin screwdriver into the slots as shown in the illustration, push downwards slightly and pry out the cover plates. Use an appropriate tool and exert pressure to unfasten locking block C from the snapon fixture, take out and re-insert on the other side having rotated the block through 180°. Unscrew hinge A from the loading door, rotate through 180°, re-insert on the opposite side and screw down. Re-insert cover plates B on the opposite site having first rotated them through 180°. Unscrew cover plates D from the front D E of the appliance, rotate through 180°, F F screw on the opposite side. Unscrew door lock E , push down slightD ly and remove from the front of the appliance. Push snap-in button F in and down, push cover down slightly and remove from front of the appliance. Change door lock E over to the opposite side, screw down the door interlock. On the other side, insert cover F and allow snap-in button to lock into place. Insert loading door and hinges into recesses on the front of the appliance and screw down. Note regarding contact protection: The appliance is only secure for operations again once all plastic parts have been inserted. You can select a programme duration from 10 mins to 3 hrs in 10-minute steps. Push the DELAY START (STARTUITSTEL) button again and again until the necessary deif the programme has to start after 12 hours. The child lock can be set to prevent a programme being accidentally started or a programme in operation being accidentally changed. the child lock function locks all buttons and the programme knob. The child lock can be activated or deactivated by holding down the LONG ANTI-CREASE (ANTIKREUK LANG) (3) and BUZZER (ZOEMER) (4) buttons simultaneously for 5 seconds. ­ Before programme is started: Appliance cannot be used ­ After programme is started: Programme in operation cannot be changed The icon appears in the display to indicate that the child safety device is activated. The child safety device is not deactivated once the programme comes to an end. If you want to set a new programme, you must first deactivate the child safety device. When program is started only current cycle phase is indicated by single icon. To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to OFF (UIT) and then reset the programme. Care and cleaning The programme cannot longer be changed directly once the programme has started. [. . . ] E51 - only dryers with the LCD): Switch the dryer off and on. 2) follow program recommendation - see Programme overview chapter 3) see Care and cleaning chapter 4) see Machine settings chapter 5) only dryers with the LCD 6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section). Only use a special bulb which is designed specially for dryers. The special bulb can be obtained from your local service centre. [. . . ]