User manual AEG-ELECTROLUX TF738

[. . . ] We promise that it'll make your life a little easier. Good luck! 136901341-00-18102007 4 electrolux Contents Operating Instructions Important safety information Product description Control panel Before first use Sorting and preparing laundry Programme overview Daily use Care and cleaning What to do if . . . Machine settings Technical data Consumption values Hints for test institutes Installation Environment 5 5 8 9 9 10 11 14 19 26 28 30 31 31 32 37 Service 39 important safety information electrolux 5 Operating Instructions Important safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. [. . . ] The laundry can be removed at any time during the anti-crease phase. To activate it: 1. Press LONG ANTI-CREASE Knitterschutz Plus button - the led above is on. 16 electrolux daily use To deselect function press again LONG ANTI-CREASE Knitterschutz Plus button. Led above is off. BUZZER (Signal) function The appliance is supplied with the BUZZER Signal function deactivated. The buzzer sounds or plays a tune when activated during: ­ cycle end ­ anti-crease phase and when phase starts or ends ­ cycle interruption by a warning ­ alarm To activate it: 1. Press BUZZER Signal button - the led above is on. To deselect function press again BUZZER Signal button. Led above is off. CHILD LOCK function The child lock can be set to prevent a programme being accidentally started or a programme in operation being accidentally changed. The child lock function locks all buttons and the programme knob. Before removing the laundry, remove fluff from the micro-fine filter. It is best to use a damp hand for this purpose. (See "Care and cleaning" chapter. ) 3. with a coffee filter) to remove any residue and small pieces of fluff. Cleaning heat exchanger If the warning led is lighting, the heat exchanger needs to be cleaned. Operating when the heat exchanger is blocked with fluff can damage the dryer. To do this, press the release button on the bottom of the door aperture and open the door in the plinth to the left. Clean fluff from the inside of the door and the heat exchanger front chamber. 4. Turn both lock washers inwards. 24 electrolux care and cleaning 5. Use the handle to pull the heat exchanger out of the base and carry it horizontally to prevent any remaining water from spilling. To empty the heat exchanger, hold vertically over a washing-up bowl. Do not use sharp objects to clean. It is best to use a brush or to rinse thoroughly with a hand-held shower. Replace heat exchanger and lock into place (turn both lock washers outwards until they snap into place). Close door in plinth. Never operate the dryer without the heat exchanger. Cleaning the drum Do not use abrasives or steel wool to clean the drum. care and cleaning electrolux 25 Lime in the water or cleaning agents may form a barely visible lining on the inside of the drum. The degree to which the laundry has been dried is then no longer detected reliably. The laundry is damper than expected when removed from the dryer. vinegar-based cleaner) to wipe down the inside of the drum and drum ribs. Clean operating screen and housing Do not use furniture cleaners or aggressive cleaning agents to clean the machine. [. . . ] Unscrew door lock F, push down slightly and remove from the front of the machine. Disconnect cable connector from door lock F. Press snap-in button G in and down, press cover down slightly and remove from front of the machine. Disconnect cable connector from cover G. [. . . ]