User manual AEG-ELECTROLUX TK7656

[. . . ] Condensation dryer TK 7656 Operating Instructions Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. The following symbols are used in the text: 1 Safety instructions 3 Useful tips and hints 2 Environmental information Warning: Notes that concern your personal safety. Attention: Notes that show how to avoid damage to the appliance. 2 Contents Instructions for use . Switching machine on / switching light on . [. . . ] It is best to use a vacuum cleaner for this purpose. Press both journals of the large mesh filter into the brackets on the loading door until they snap into place. Re-insert fine strainer. 3 If the fine strainer is not fitted, the large mesh 10. Press against the large mesh filter until it locks into the interlock. filter will not snap into place and the loading door cannot be closed. Cleaning the door seal Wipe the door seal with a damp cloth immediately after the drying cycle has finished. 14 Emptying the condensate tank Empty condensate tank after every drying cycle. If the condensate tank is full, an active programme will break off automatically and the EMPTY WATER (BEHÄLTER) display will light up. In order to continue the programme, the condensate tank must first be emptied. 1 Warning!The condensate is not suitable for drinking or for preparing foodstuffs. Pull drawer containing condensate tank out all the way (1). Pull out condensate tank's outlet connections (2). 3 The condensate tank has a volume of approx. 2. Pour condensate out into basin or other suitable container. Slide outlet connections in and refit condensate tank. If the programme has been interrupted as a result of the condensate tank being full: Press the START/PAUSE button to continue the drying cycle. This is sufficient for around 6kg of laundry which has previously been spun at 800 revolutions/minute. 3 The e. g. However first filter condensate can be used as distilled water, the condensate (e. g. with a coffee filter) to remove any residue and small pieces of fluff. 15 Cleaning heat exchanger If the HEAT EXCHANGER (WÄRMETAUSCHER) display is illuminated, the heat exchanger needs to be cleaned. 1 Caution!Operatingcan damageheat exchanger when the is clogged with lint the dryer. This also increases energy consumption. To do this, press the release button located beneath the loading aperture and open the base door to the left. Remove lint from the inside of the door and the heat exchange chamber. Wipe the door seal with a damp cloth. 4. Turn both lock washers inwards. 1 Caution!Do not use sharp objects to The heat 5. Use the handle to pull the heat exchanger out of the base and carry it horizontally to prevent any remaining water from spilling. [. . . ] 14. Insert loading door and hinges into recesses on the front of the machine and screw down. 15. Once the door stop has been replaced, check the function of the DOOR (TÜR) button. Note regarding contact protection: The machine is only secure for operations again once all plastic parts have been inserted. Special accessories The following special accessories are available from your Service Force Centre or your specialist dealer: Intermediate installation kits for stacked washer and dryer: These intermediate installation kits can be used to arrange the dryer and an automatic FUST washing machine (60cm wide, front loading) as a space-saving washer/dryer stack. The automatic washing machine is at the bottom and the dryer is at the top. [. . . ]