User manual AEG-ELECTROLUX TKSL2E100

[. . . ] user manual Condenser Dryer TK SL2 E We were thinking of you when we made this product electrolux 3 Welcome to the world of Electrolux You've chosen a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. Electrolux ambition is to offer a wide variety of quality products that would make your life even more comfortable. You can look at some examples on the cover in this manual. But now it's time to study this manual and start using and enjoying the benefits from your new machine. [. . . ] in case of CUPBOARD programme the following status icons are visible: . Current cycle progress is marked by flashing dash under status icon. When appropriate part of drying cycle is accomplished dash becomes steady and appears flashing under next status icon. Changing programme To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to OFF Aus and then reset the programme. daily use electrolux 25 The programme can no longer be changed directly once the programme has started. If nevertheless there is an attempt to change the programme on the programme knob, the programme progress display and the maintenance indicators flash. If an option button (excluding the BUZZER option) is pressed, Err appears in the multidisplay. The drying programme is not however affected by this (laundry protection). Putting in extra items or taking items out before end of programme 1. Open loading door. Laundry and drum can become hot. Press the Start/Pause button to continue the drying cycle. Drying cycle complete / removing laundry Once the drying cycle is complete, display shows a blinking "0", under anticrease icon appear dash. If the BUZZER option has been chosen, an acoustic signal sounds intermittently for about one minute. The drying cycles are automatically followed by an anti-crease phase which lasts around 30 minutes. The drum rotates at intervals during this phase. This keeps the laundry loose and free of creases. The laundry can be removed at any time during the anti-crease phase. (The laundry should be taken out towards the end of the anti-crease phase at the latest to prevent creases from forming. ) If LONG ANTI-CREASE function has been selected, the anti-crease phase is lengthened by 60 minutes. Before removing the laundry, remove fluff from the micro-fine filter. It is best to use a damp hand for this purpose. (See "Care and cleaning" chapter. ) 3. Remove laundry. 26 electrolux daily use 4. Turn the programme selector to OFF Aus. After each drying cycle: - Clean the micro-fine filter and fine filter - Drain the condensed water container (See chapter "Care and cleaning". ) 5. Close the door. care and cleaning electrolux 27 Care and cleaning Cleaning fluff filter The filters collect all the fluff which accumulates during drying. To ensure that the dryer works perfectly, the fluff filters (micro-fine filter and fine strainer) must be cleaned after every drying cycle. The warning icon is on to remind you this operation. Never operate the dryer without fluff filters or with damaged or blocked fluff filters. Use a damp hand to clean the micro- fine filter, which is built into the lower part of the loading aperture. [. . . ] On the other side, insert the cable connector in cover G, insert cover and allow snap-in button to lock into place. Insert loading door and hinges into recesses on the front of the machine and screw down. Note regarding contact protection:The machine is only secure for operations again once all plastic parts have been inserted. Special accessories Intermediate installation kit for stacked washer and dryer: Available from your Service Force Centre or your specialist dealer These intermediate installation kits can be used to arrange the dryer and an automatic Electrolux washing machine (60cm wide, front loading) as a space-saving washer/dryer stack. The automatic washing machine is at the bottom and the dryer is at the top. [. . . ]