User manual AEG-ELECTROLUX TM63600

[. . . ] TM 43600 / TM 63600 Teppan Yaki Grill plate Installation and Operating Instructions Dear Customer, Please read these user instructions carefully and keep them to refer to later. Please pass the user instructions on to any future owner of the appliance. The following symbols are used in the text: 1 3 2 Safety instructions Warning!Information that affects your personal safety. [. . . ] · When fitted in combustible material, the local fire-protection regulations must be observed without fail. · Limit to room width 550 mm, height 127 mm from lower side of grill plate, depth 560 mm from rear with a working surface depth of 600 mm. Combustible walls and ceilings must be provided with a flame-retardant lining above the grill plate in conformity with the official fire regulations for the relevant area. · Protection against contact must be ensured by the installation. Electrical connection · Electrical connection must be made by a certified installer. · The mains connection to the built-in switchbox must be made with the existing connecting cable and corresponding to the connection diagram. · A device must be provided in the electrical installation which allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm. Suitable isolation devices include line protecting cut-outs, fuses (screw type fuses are to be removed from the holder), earth leakage trips and contactors. While being serviced the appliance must be disconnected from the power supply. The rating plate is fitted on the underside of the built-in switchbox. 16 · Before putting into operation detach any protective foil from the grill plate. · After connecting to the power supply all grill plates should be switched on briefly (approx. 2 minutes) in succession at the 100 °C position to check their readiness for operation. Rating plates Versions with two thermostats Model Code TM 63600 PNC 949 480 194 Versions with one thermostat Model Code TM 43600 PNC 949 480 193 17 Fitting/installation in working surface: surface mounting (coated, lined, Inox or stone) When fitting in combustible material, the laws, ordinances, directives and standards in force in the country of use as well as the local fireprotection regulations are to be followed. The lateral spacing of the working surface cut-out from a high-level cabinet and the rear wall must be at least 50 mm. Cut out working surface according to specified cut-out dimensions. Seal the cut-out area of the working surface against moisture with suitable varnish. Holes for the built-in switchbox in the front of the cabinet with template as illustrated. Guide the built-in switchbox with the bundle of connecting conductors from above through the working surfaces cut-out and from the rear to the front of the cabinet. Important: There are capillary tubes in the bunch of conductors between the built-in switchbox and the grill plate. Do not bend sharply or separate or the appliance will be destroyed!Assembly with CN-front panel (CN) Guide the signal lamps from the rear through the 12 mm dia. holes in the front of the cabinet (the 12 mm dia. holes can be enlarged to 15 mm to simplify assembly). Take the switch spindle(s) of the built-in switchbox from the rear through the 13 mm dia. [. . . ] Clean grill plate and working surface in area of joint (e. g. with isopropyl alcohol and fluff-free cloth) and fill the joint with a heat-resistant (at least 160 °C) silicone joint sealing compound. Note: Since the grill plate and working surface cut-out are subject to a certain dimensional tolerance, the width of the joint can vary (min. Remove power supply from built-in switchbox/grill plate. [. . . ]