User manual AEG-ELECTROLUX TN95671

[. . . ] Technical data Installation Environmental concerns The following symbols are used in this user manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Subject to change without notice 4 Safety information SAFETY INFORMATION In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] Do not use detergents or abrasive powders, as these will damage the finish. Check that the drain hose at the rear of the cabinet discharges into the drip tray. Daily use 11 DAILY USE Movable shelves The walls of the refrigerator are equipped with a series of shelves support so that the shelves can be positioned as desired. Some shelves must be lifted up by the rear edge to enable them to be removed. Do not move the glass shelf above the vegetable drawer to ensure correct air circulation. Vegetable Drawer The drawer is suitable for storing fruit and vegetables. Some models have a separator inside the drawer that can be placed in different positions to allow for the subdivision best suited to personal needs. All parts inside the drawer can be removed for cleaning purposes. Bottle rack Place the bottles (with the opening facing front) in the pre-positioned shelf. If the shelf is positioned horizontally, place only closed bottles. 12 Daily use This bottle holder shelf can be tilted in order to store previously opened bottles. To obtain this result, pull the shelf up so it can rotate upwards and be placed on the next higher level. Clean Air Control Filter Your appliance is equipped with a carbon filter behind the air lever flap. Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator. Hints for temperature inside the fridge A suitable temperature inside the fridge is approx. When the temperature regulator is set to +5°C this represents the mean temperature in the fridge. It is normal with higher temperature in the top of the fridge. Pull the grille straight out to completely remove it. Vacuum clean under the cabinet. 16 What to do if. . . Defrosting the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a drain hole into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Periods of non-operation When the appliance is not in use for long periods, take the following precautions: 1. disconnect the appliance from electricity supply 2. defrost and clean the appliance and all accessories 4. leave the door/doors open to prevent unpleasant smells. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. WHAT TO DO IF. . . During operation of the appliance some smaller but annoying trouble can often occur, which does not require calling a technician out. In the following chart information is given about them to avoid unnecessary charges on service. The operation of the appliance goes with certain sounds (compressor and circulating sound). This not means a trouble, but a normal operation. [. . . ] On delivery the carbon filter is in a plastic bag to preserve performance. Take the filter out of the plastic bag. Installation 3. Insert the filter in the slot found in the back of the air lever flap. The filter should be handled carefully so fragments do not loosen from the surface. [. . . ]