User manual AEG-ELECTROLUX TR1770

[. . . ] Never stop a tumble dry before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. Important safety information Environment Installation Product description Control panel Before first use Programme overview 67 69 69 72 73 74 74 Daily use 76 Care and cleaning 80 What to do if . In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. [. . . ] Unscrew cover plates D from the front of the machine, rotate through 180°, screw on the opposite side. Unscrew door lock E , push down slightly and remove from the front of the machine. Press snap-in button F in and down, press cover down slightly and remove from front of the machine. Change door lock E over to the opposite side, screw down the door interlock. On the other side, insert cover F and allow snap-in button to lock into place. Insert loading door and hinges into recesses on the front of the machine and screw down. Note regarding contact protection: The machine is only secure for operations again once all plastic parts have been inserted. special accessories · Stack kit Available from your Service Force Centre or your specialist dealer These intermediate installation kits can be used to arrange the dryer and an washing machine (60 cm wide, front loaded) as a space-saving washer/dryer stack. Read carefully the instructions supplied with the kit. ⷠDrain kit Available from your Service Force Centre or your specialist dealer Installation kit for direct draining of condensate into a basin, siphon, gully, etc. The condensate tank then no longer has to be drained, it must however remain in its intended position in the machine. By turning the knob choose a drying programme. The buzzer sounds or plays a tune during: ­ cycle end ­ anti-crease phase and when phase starts or ends ­ cycle interruption by a warning ­ alarm TIME (Zeitwahl) Operates only with TIME PROGRAMME (Zeitprogramm) . Child lock The child lock can be set to prevent a programme being accidentally started or a programme in operation being accidentally changed. the child lock function locks all buttons and the programme knob. The child lock can be activated or deactivated by holding down the OPTION and OK buttons simultaneously for 5 seconds. ­ Before programme is started: Appliance cannot be used ­ After programme is started: Programme in operation cannot be changed The icon appears in the display to indicate that the child safety device is activated. The child safety device is not deactivated once the programme comes to an end. If you want to set a new programme, you must first deactivate the child safety device. From left to the right, from iron dry to anti-crease icon depends on the drying cycle chosen. In case of cupboard dry programme the following status icons are visible: . current cycle progress is marked by flashing dash under status icon. [. . . ] The special bulb can be obtained from your local service centre. When the appliance is switched on, the interior lighting switches itself off after 4 minutes when the door is open. These develop too much heat and may damage the appliance!Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully unscrew or deactivate the fuse. [. . . ]