User manual AEG-ELECTROLUX TS1850-4RH

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance. [. . . ] Led above stops flashing, becomes steady. Lighting status LED shows you cycle run. Changing programme To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to OFF UIT position. The programme is cancelled. 16 Daily use The programme can no longer be changed directly once the programme has started. Open loading door Use a damp hand to clean the micro- fine filter, which is built into the lower part of the loading aperture. 3. After a period of time, a patina due to detergent residue on laundry forms on the filters. When this occurs, clean the filters with warm water using a brush. Remove the filter from the door pulling it out. It can be positioned with the tooth facing to the left or to the right). After cleaning do not forget to put it back. Care and cleaning 4. Push down unlock button on large mesh filter. It is best to use a damp hand for this purpose. Clean the entire filter area The strainer area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. Replace heat exchanger and lock into place (turn both lock washers outwards until they snap into place). Never operate the dryer without the heat exchanger. Cleaning the drum CAUTION!Do not use abrasives or steel wool to clean the drum. Lime in the water or cleaning agents may form a barely visible lining on the inside of the drum. The degree to which the laundry has been dried is then no longer detected reliably. The laundry is damper than expected when removed from the dryer. vinegar-based cleaner) to wipe down the inside of the drum and drum ribs. Care and cleaning 23 Clean operating screen and housing CAUTION!Do not use furniture cleaners or aggressive cleaning agents to clean the machine. Use a damp cloth to wipe down the operating screen and housing. 24 What to do if . . . What to do if . . . Troubleshooting by yourself If, during operation, the dryer shows an error (one or more leds flashing on the control panel), check first of all whether you can remedy the problem yourself by means of the table below. If you cannot solve the problem: Switch the machine off and on again. Press the START PAUSE START PAUZE button. [. . . ] Disconnect cable connector from door lock F. Press snap-in button G in and G down, press cover down slightly and remove from front of the machine. Disconnect cable connector from cover G. Change door lock F over to the opposite side, insert the cable connector and screw down the door interlock. [. . . ]