User manual AEG-ELECTROLUX TWISTER, Z5810 EURO

[. . . ] Never stop a tumble dry before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. Contents Thank you for choosing one of our high-quality products. To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. [. . . ] Unscrew cover plates D from the front D E of the appliance, rotate through 180°, F F screw on the opposite side. Unscrew door lock E , push down slightD ly and remove from the front of the appliance. Push snap-in button F in and down, push cover down slightly and remove from front of the appliance. Change door lock E over to the opposite side, screw down the door interlock. On the other side, insert cover F and allow snap-in button to lock into place. Insert loading door and hinges into recesses on the front of the appliance and screw down. Note regarding contact protection: The appliance is only secure for operations again once all plastic parts have been inserted. Stacking kit These intermediate installation kits can be used to arrange the dryer and a washing machine (60 cm wide, front loaded) as a space-saving washer/dryer stack. the washing machine is at the bottom and the dryer is at the top. Read carefully the instructions supplied with the kit. Available from your Service Force Centre or your specialist dealer · draining kit Installation kit for direct draining of the condensed water into a basin , siphon , gully , etc. The child lock can be activated or deactivated by holding down the LONG ANTI-CREASE (ANTI-KREUK PLUS) and BUZZER (ZOEMER) buttons at the same time for 5 seconds. ­ Before programme is started: Appliance cannot be used ­ After programme is started: Programme in operation cannot be changed The padlock symbol appears in the display to indicate that the child safety device is activated. The child safety device is not deactivated once the programme comes to an end. If you want to set a new programme, you must first deactivate the child safety device. From left to the right, from iron dry to anti-crease icon depends on the drying cycle chosen. In case of cupboard dry programme the following status icons are visible: . current cycle progress is marked by flashing dash under status icon. When appropriate part of drying cycle is accomplished dash becomes steady and appears flashing under next status icon. To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to OFF (UIT) and then reset the programme. The programme cannot longer be changed directly once the programme has started. The drying programme is not however affected by this (laundry protection). [. . . ] When the appliance is switched on, the interior lighting switches itself off after 4 minutes when the door is open. These develop too much heat and may damage the appliance!Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully unscrew or deactivate the fuse. Unscrew cover above the bulb (this can be found directly behind the loading aperture, at the top; refer to "Description of machine" section. [. . . ]