User manual AEG-ELECTROLUX TWSLEEV101

[. . . ] Important Pour des raisons de sécurité et dans le but de garantir un usage correct de l'appareil, nous vous invitons à lire attentivement cette notice d'utilisation, ainsi que les recommandations et les avertissements qu'elle contient avant de procéder à l'installation et à la première utilisation de l'appareil. Per rinfrescare i tessuti (note for the author: in Italy we don't have these kind of product for dry cleaning - please remove the note) Share more of our thinking at www. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. [. . . ] This might cause heat built-up which would interfere with the operation of the appliance. The appliance must therefore not be installed on floors which are not resistant to high temperatures. When operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance. Should the appliance be moved, it must be transported vertically. Pull off adhesive strips from inside machine on top of drum. Electrical connection Details on mains voltage, type of current and the fuses required should be taken from the type plate. The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precautions. Should the appliance power supply cable need to be replaced, this must be carried out by our Service Center. The power supply cable must be accessible after installing the machine. On the other side, insert cover F and allow snap-in button to lock into place. Insert loading door and hinges into recesses on the front of the machine and screw down. Note regarding contact protection: The machine is only secure for operations again once all plastic parts have been inserted. special accessories · Stack kit Available from your Service Force Centre or your specialist dealer These intermediate installation kits can be used to arrange the dryer and an washing machine (60 cm wide, front loaded) as a space-saving washer/dryer stack. the washing machine is at the bottom and the dryer is at the top. Read carefully the instructions supplied with the kit. Drain kit Available from your Service Force Centre or your specialist dealer Installation kit for direct draining of condensate into a basin, siphon, gully, etc. The condensate tank then no longer has to be drained, it must however remain in its intended position in the machine. Read carefully the instructions supplied with the kit. Pedestal with the drawer Available from your Service Force Centre or your specialist dealer To situate the dryer in optimal high and have some additional space to store (e. Read carefully the instructions supplied with the kit. Unscrew hinge A from the front of the machine and take off the loading door. To do this, insert a thin screwdriver into the slots as shown in the illustration, press downwards slightly and pry out the cover plates. [. . . ] Select time programme or higher drying level (e. E51 - only dryers with the LCD): Switch the dryer off and on. 2) follow program recommendation - see Programme overview chapter 3) see Care and cleaning chapter 4) see Machine settings chapter 5) only dryers with the LCD 6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section). changing the bulb for interior lighting Important! [. . . ]