User manual AEG-ELECTROLUX TY58.3AL

[. . . ] Please observe these without fail. 1. These numbers indicate step-by-step how to use the appliance. . . . 3 2 This symbol is followed by supplementary information for the operation and practical use of the appliance. This symbol indicates tips and advice for the economic and environmentally-friendly application of the appliance. · Our WORKS CUSTOMER SERVICE is available close at hand at all times in case of technical problems (addresses and telephone numbers can be found in the section , , Customer service offices"). [. . . ] (the strips of meat should not touch) 10 Cooking material Beef Beef steak very rare rare medium well done Temperature (°C) 200­220 220 220 220 220 200 200 100 Time/tips Preheat grill plate 2 mins. , turn after 1 min. without fat the times are increased by around 20 % 6­8 mins. , turn after 3­4 mins. Roast meat in oil fully on all sides (only turn when the meat detaches) 10 Min. finish cooking on one side Preheat grill plate 8 mins. , turn after 4 mins. (according to thickness) 8 mins. , turn after 4 mins. 8­10 mins. , turn several times 6­8 mins. , grill well from all sides Preheat grill plate 10 mins. , turn after 5 mins. Before you call on the customer service Make sure that no operating errors have occurred. If you call on the customer service Make a note of the following data given on the rating plate on page 15 of the operating instructions: ­ Model Code TY . Please always specify these data: ­ When requesting customer service ­ When ordering spare-parts or accessories ­ With technical inquiries Make an exact note of your observations to simplify the work and preparations of our service engineer. Dial the service number (see "Customer service"). Your call will be directed automatically to the nearest service centre. Cut out working surface according to specified cut-out dimensions. Seal the cut-out area of the working surface against moisture with suitable varnish. Holes for the built-in switchbox in the front of the cabinet with template as illustrated. Guide the built-in switchbox with the bundle of connecting conductors from above through the working surfaces cut-out and from the rear to the front of the cabinet. Warning: There are capillary tubes in the bunch of conductors between the built-in switchbox and the grill plate. Do not bend sharply or separate or the appliance will be destroyed!5a. Assembly with CN-front panel (CN) Guide the signal lamps from the rear through the 12 mm dia. holes in the front of the cabinet (the 12 mm dia. holes can be enlarged to 15 mm to simplify assembly). Take the switch spindle(s) of the built-in switchbox from the rear through the 13 mm dia. hole(s) and insert the signal lamps in the signal lamp lenses mounted on the CN front panel from the rear. [. . . ] Warning: If not fitted correctly, removal would be made more difficult for servicing. The grill plate and working surface could be damaged in this way. Place grill plate carefully in cut-out and align so that the joint is the same size on all sides, The grill plate is not fastened!Warning: A recess base which can be dismantled must be fitted as contact protection under the grill plate/built-in switchbox. [. . . ]