User manual AEG-ELECTROLUX UN64TM

[. . . ] The indicator light on the nozzle will come on when BRUSH is operating. After vacuuming rewind the power cord by pushing the REWIND button. Gre 6 Tips on how to get the best results / Tip til, hvordan du opnår de bedste resultater Models with manual power regulation: Modeller med manuel styrkejustering: See the reference numbers below to find an optimal performance. ) Models with display and remote control: Modeller med skærm og fjernbetjening: Follow the numbers for optimal performance. [. . . ] The dust container must never be overfilled. Let dry completely before putting back !Remove the cyclonic filter by pulling out the filter grip. Let it dry completely before putting it back into the dust container. Clean the foam filter every 3-4 months or when it's visually dirty. Allow it to dry for 6-12 hours before putting it back. Put the dust container back until it clicks into place. Replacing / Cleaning the exhaust filter Udskiftning/rengøring af udsugningsfilteret 9 eng Cleaning the washable exhaust filter Wash the filter every three months. If the filter is damaged, replace it with a new filter. rinse the inside (dirty side) in lukewarm tap water. Tap the filter frame to remove the water. Check that the plug and cable are not damaged. The vacuum cleaner stops · check if dust container is full. If so, empty it and clean both the dust container and the filters before putting it back in the cleaner. Check the motor and exhaust filter are clean. The cleaner stops The cleaner might be overheated: disconnect it from the mains; check if the nozzle, tube or hose are blocked. Let the cleaner cool down for 30 minutes before plugging it in again. If the cleaner still does not work, contact an authorized Electrolux service centre. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to hoses caused by cleaning them. Water has entered the vacuum cleaner It will be necessary to replace the motor at an authorized Electrolux service centre. Damage to the motor caused by the penetration of water is not covered by the warranty. [. . . ] If the cord is damaged, it must be replaced only by an authorized Electrolux service centre in order to avoid a hazard. Damage to the vacuum cleaner's cord is not covered by the warranty. Never pull or lift the vacuum cleaner by the cord. all servicing and repairs must be performed by an authorized Electrolux service centre. [. . . ]