User manual AEG-ELECTROLUX USR 200

[. . . ] (There is a risk of damage to the appliance. ) · It is essential that the slide be used (Fig. 1/D) may only be removed in the case that the size and shape of the item to be sliced is such as to prevent their use (e. g. · Switch off the appliance after a maximum of 5 minutes continuous use, the Universal Slicer is designed for a maximum period of operation of 5 minutes. · After each use, return the stop plate (Fig. [. . . ] Please Note: The circular blade continues to rotate for a short time after the appliance is switched off. After each use, please return the stop plate to its initial position (, , 0" position) by turning the slice thickness adjustment knob (Fig. 2). Prior to Using · Check that the appliance is stable and connect to the mains using the mains plug. · Set the required slice thickness. To do this, turn the slice thickness adjustment knob (Fig. The slice thickness adjustment scale (Fig. 1/J) is not graduated in millimetres, it is an arbitrary scale for your reference. The , , 0" position is designed to cover the blade for safety reasons. Lift up the rear wall of the slide until it is at 90º and then press downwards to the stop. · Fitting the slide and the holder. 4) and place in the guide slot on the side of the slicing table, swivel into the working position. Place the holder on the slide from the right. Instructions for Use To use the Universal Slicer safely and ensure even slicing, place the item to be sliced on the slide and press it, if necessary using the holder, lightly against the stop plate (Fig. With the circular blade rotating, the slide is then moved, together with the item to be sliced, towards the circular blade, apply light pressure. After use, return the stop plate to the , , 0" position using the slice thickness adjuster. Collecting the Slices Place, for example, a plate in the cutout in the housing (Fig. 7). Removing the Circular Blade Prior to removing the circular blade, it is imperative that the stop plate be placed in the , , 0" position and that the appliance is unplugged from the mains. When carrying out the following steps, please do not forget: The circular blade is very sharp!8) by turning it clockwise (left hand thread). The circular blade can now be removed from the housing cover. Switching On the Universal Slicer The Universal Slicer is switched on by applying thumb pressure to the switch (Fig. At the same time the safety interlock must be disengaged with another finger (Fig. The circular blade continues to rotate as long as the switch remains pressed. [. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. 2 W Cleaning With the exception of the motor unit with the mains cable, your appliance is dishwasher safe. Cleaning is only to be performed when the circular blade is stationary. [. . . ]